How to mend Tamper Working Alarm

2

alarm activating when code put in showing sterling tamper?

I have a sterling 10 alarm system that has been working up untill this morning it was installed in 2006.When i... [Read more]

12

How can i wire my bell box?

Hi I replaced my scantronic 9450 alarm panel with scantronic 9651.I have got the pirs and door co... [Read more]

7

Accenta 8 outside siren not working?

We recently had some painting work done to the outside of the house and the contractor (bless him) silenced th... [Read more]

1

SL compact alarm?

Hi I have an SL compact alarm system with 3 separate key pads . The problem is there is no red power L.E.Ds ... [Read more]

9

Delay alarm going off citadel?

Hi It's me again! I have a new problem now and I was wondering if you could help seen as you did last time. ... [Read more]

3

Captiv8 alarm?

What is "ZEX TAMPER"? This message along with "ENGINEER RESET" is now being displayed on our keypad. I have ... [Read more]

5

pyronix home alarm?

My granddaughter activated the alarm by pressing the panic button located in our master bedroom whilst playing... [Read more]

6

How Can I reset Scantronic 9651 House Alarm?

Hi, I moved into a rental property last year and the alarm has never been working, the landlord won`t sort ... [Read more]

2

Friedland Wireless Alarm 433mhz?

My alarm has been working perfectly for 7 years and now the remote control is not communicating with the contr... [Read more]

7

scantronic 9452?

Internal alarm keeps sounding. was working fine until last week, however now keeps sounding. I have replaced... [Read more]

15

Accenta G4 mini and remote keypad only illuminating?

I recently had an issue with my Accenta G4 alarm and remote keypad. For some unknown reason the tampers were a... [Read more]

7

Scantronic 9600 showing tamper unit tamper?

Hi Alarm been working for years (we didn't install it) now when we try and set it, after putting in the cod... [Read more]

11

Logic 4 Alarm?

I have just moved into a house and it has a Logic 4 Alarm system. I have no instruction manual and don't even ... [Read more]

2

Accenta keypad key lights on,power light off,keypad not working?

My wife was painting inside a cupboard and touched 2 cables,the alarm went off, tried to enter code but no eff... [Read more]

6

Accenta G3 goes off when un-set?

Our Accenta G3 has gone off three times, always in the early hours of the morning, whilst being un-set. The p... [Read more]

7

Accenta 8 mini alarm fault?

Hi Sunny, just moved into the house and i have an accenta 8 mini alarm system installed, which was working fi... [Read more]

1

how do you remove the tamper light and get alarm working again?

we recently had a power shortage and the alarm went off managed to turn it off but the tamper light now on and... [Read more]

2

alarm tamper reset required ?

I have just painted my hall and had to move the alarm pad to paint behind it, but now I have a flashing messag... [Read more]

2

Tried re booting concept 6 but still shows tamper ?

following elec cut my concept 6 alarm shows Tamper and I cant get it to go to the normal day mode. Have tried ... [Read more]