Hi
It's me again! I have a new problem now and I was wondering if you could help seen as you did last time.
When I set my alarm, the pir sensors in the rooms do pick you up so I know they are working. However, once the alarm has set, if I walk into a room the alarm does not go off until about 1hr 15 min later!! When it does eventually set off, it turns straight off when I key in my code and does show the correct room that I did go in earlier. The tamper light shows on the keyboard though. Any ideas!
Hi
I tried what you said and it worked!!!! Thank you ever so much!! I really appreciate your help again.
Alex
Alex
December 2013
IIRC the plus and G3 models have a programmable bell delay of up to 99 mins.
So if you have accidentally pressed the wrong buttons whilst in engineering??.
Just a thought :)
e manno
December 2013
Haha! Thanks very much for your advice. I will try that and get back to you :) :)
Alex
Alex
December 2013
We like our scantronic's Alex :)
Worth going into engineering and check the bell delay timer.
It's feature is mainly used on monitored systems.
See, bell delay active means no bells so the boys in blue respond and catch intruder in the act.Yeh right ... charge of the light brigade and heard a mile away.
Lazy feckers.
Worth checking it's easily done,
So once in engineering press 7 then 2 for bell delay then enter 00 that turns bell delay off then press reset twice.
e manno
December 2013
not being rude mate invest in a scantronic 9651 you wont go wrong
gts
December 2013
Oh ok thanks!
Alex
December 2013
yes get rid of that panel its rubbish
gts
December 2013
Automatic Answer
We may have found other answers which could help you.
howtomendit.com for free repair help, information and advice.
Try fixfault.com to fix home alarm systems.