Internal alarm keeps sounding. was working fine until last week, however now keeps sounding. I have replaced the battery but it keeps going off and the panel shows tamper zone2 and the tamper, service, fault lights are flashing. the users manual and installation guide just say call an engineer. Surely there must be a way to reset the system?
as e manno has said,scanny panels are very reliable,and I can safely say 99 % of probs about scanny on here are user probs,not the panel
gts
June 2013
look for cut cable mate or a loose pir cover
gts
June 2013
ty, will be doing as advised.
jh
June 2013
You said it mate and I agree with you totally :)
e manno
June 2013
like I said e manno,scanny panels are a lot smarter than the users,its telling him whats wrong .,but he dithering around like a blind sow at a weenie roast !!!!!
gts
June 2013
ditto !
gts
June 2013
Trace and correct the tamper on the system,then use the engineering code to reset the panel.
It's likely to be set up for engineers not user reset,the flashing service led is a good indication that the panel needs this.
It's a great robust little scanny you have there :)
Either read and understand the manual or call in a pro because it's well worth the cost of a visit.
howtomendit.com for free repair help, information and advice.
Try fixfault.com to fix home alarm systems.