How to mend Fault

9

ADT 3200 House Alarm?

My system has reported a fault and it comes up with Sr. I have changed the battery, and the internal alarm buz... [Read more]

1

panel showing lid tamper?

on my scantronic9651 power went off then after power reinstated it showing lid tamper. i took lid off n put ba... [Read more]

8

zone 8 fault?

when trying to set the alarm to leave it bleeps and wont set and the red zone 8 light comes on

2

Accenta Alarm?

My alarm exit and entry warning appears to have a fault ,one setting alarm exit tone sounds but when i open do... [Read more]

4

accenta mini 8 fault?

the alarm appears to be working correctly only does not sound if any sensor activated. enter code to set alarm... [Read more]

3

accenta 8 mini fault?

enter code exit tone goes for about 10 min when re -entering house entry tone operates if i enter code switche... [Read more]

4

End panel scantronic 9800+ 16?

BF shown on keypad highlighting fault with battery. Battery is not fully charging i.e. cahrging at 10.2v as op... [Read more]

2

getting 6F fault, ?

6F is a zone , i take it,also fault & service lights are illuminated have disabled sensor in that zone , but ... [Read more]

3

I have a scantronic 9800 alarm system with a 9827 key pad?

I have a scantronic 9800 alarm system with a 9827 key pad and during the evening whislt the alarm was unset it... [Read more]

2

Scandronic 9751 alarm chirping in cold weather?

My alarm bellbox is chirping in cold weather, below -9 degrees, kept us awake all night, unit is 3 years old, ... [Read more]

1

Scantronic 9800 External bell box fault?

My external sounder went of in the bad weather - turns out some tracks on the circuit board had corroded - any... [Read more]

3

Scantronic 9834?

Upon moving into our new home the alarm panel (Scantronic 9834) showed a Sr fault (total power failure). The b... [Read more]

setting fault accenta/optima.gen 4?

arm alarm with code no problem then goes in to saying setting fault 6 bedroom 1 ? not sure why will not arm...

3

Scantronic 9800 External bell fault?

Hello Guys, My external bell went off last night, but nothing was indicated on the control panel . It stopped... [Read more]

5

Veritas 8 alarm fault?

My veritas 8 alarm won't set, the unset light is flashing on the entry panel and the main panel power light is... [Read more]

1

setting fault?

i have just installed a accenta system i have a pir and a door contact in my exit route both are set as timed ... [Read more]

2

Scantronic 9800: Changed battery. Now wants remote reset?

Had a bF code on our alarm this morning - usually inputting our customer code clears this and the internal sir... [Read more]

1

how do i fix a fault lock out on a ACE Accenta+ ?

My husband cut a wire on the alarm system,alarm went off and the tamper light came on. We tried to reset it a... [Read more]

input the codes into scantronic 9450 wired alarm?

Hi, I am trying to assist my 93 year old neighbour with his faulty alarm system. After a recent power-cut, his... [Read more]

Accenta G4 setup?

After installing this unit which seemed to go ok and in the Engineers mode it appears to sound the alarm, oper... [Read more]