How to mend Control

6

Alarm box getting warm?

Just recently we have nticed our alarm mains control box getting warm and now the wall directly above it is ma... [Read more]

16

how to wire a pyronix deltabell plus bellbox?

what are the wiring connections for a pyronix deltabell plus to a optima xm6 control panel

4

Moss Response MS2000 Alarm System?

Unit does not operate from any of the radio remote controls sensors. Would seem the radio receiver part in the... [Read more]

4

how can I fix my scantronic hardwired control panel 9448+ outside alarm box?

Hi, we have a hardwired control panel 9448+ alarm system. The outside box does not flash and nor is the alar... [Read more]

11

Veritas 8?

The alarm on my house has never been used for years. I think I know the code but I am not 100% sure. The Ver... [Read more]

1

Nexus 8 alarm?

Nexus 8 burglar alarm bell/strobe activated 6/1/13 even though system not set, i.e. house was occupied at the ... [Read more]

4

Risco GT-480 Strobe stays on?

Hi I recently moved house, and there's ageneric alarm fitted. I've tracked it down as a Risco, the control pa... [Read more]

6

Response low battery warning?

The low battery warning led if flashing on the control panel but I don't know which battery and where,i presum... [Read more]

20

Scantronic 9651 - Tamper Lid Reset required?

Hi I'm trying to fix my alarm after taking lid of control panel off (stupid mistake to make) and after gogglin... [Read more]

8

How to switch off Tamper light permanently on in Accenta after fuse change?

The lights on the dial of an Accenta 8 Burglar Alarm system went off. Checked and replaced a blown fuse in the... [Read more]

4

gardtec 800 alarm system reset?

I have a gardtec 800 series alarm system. This was installed by the previouse house owner. Last night the inte... [Read more]

4

9200 series Alarm?

The alarm as worked no problems for over the five years we have been in house, and had it serviced on moving i... [Read more]

7

fault code Lt on 9800 alarm?

Hi I have a fault code Lt on my display, in the manual it says control panel tamper, Ive opened and cloesd thi... [Read more]

3

LP1-4000?

We have just moved into a house with an alarm on the front of the house the control panel is in the hall way b... [Read more]

3

Idiots guide required for wiring Accenta G4 to a Pyronix Delta Bell?

I have managed to wire the complete alarm system, 3 x PIRs, 1 x Door Contact, Control Box and LCD Key pad, all... [Read more]

7

ReActivate Micromark MM9490A Burglar Alarm?

We have moved into a new house and the alarm has power to the control panel (led working and when I trip the p... [Read more]

37

How do I fix 9930 control panel?

Can some one please help - when the alarm is in set mode using the 9930 control panel it starts sounding in th... [Read more]

10

new control panel query?

Can any of you experts out there tell me what would make 3 PIR units fail after fitting a new control panel

4

Accenta plus 2?

I need to change the battery on my alarm, but i'am a little confused after finding what resembles a banana ski... [Read more]

5

Scantronic 9800 fault?

Just come home, unset alarm as usual. Noticed shortly after the display on control panel displayig bf. Unders... [Read more]