Mend > Home Alarm Systems

No mains power light to my keypad?

i have a scantronic 9800 Micro processor intruder alarm originbal fault was faulty battery back up so i change... [Read more]

How can I activate my door chime on my Accenta alarm?

Since the alarm was activated, I believe in my haste to turn off the alarm, the front door chime has been deac... [Read more]

Scantronic alarm?

Hello all hope you can help?. Had an engineer out a fortnight ago now who replaced a sensor and the batteri... [Read more]

my lights and alarm is not going of on the out side ?

my lights and out side alarm are not working only the inside alarm is working why is this please

how to wire a pyronix deltabell plus bellbox?

what are the wiring connections for a pyronix deltabell plus to a optima xm6 control panel

Logic 6 ?

How can you change the time for entry?,it only gives us around ten seconds at the moment and need more time to... [Read more]

Pyronix home alarm?

How can i remove the installers name and tel no from my key pads please.

How do I change the batteries of my Paragon Super house alarm?

Do I turn off the alarm or do I just open the case while its still alive and working and remove the battery/ba... [Read more]

veritas 8 unset led?

i have a veritas 8 alarm system came back one day put unset code in but unset led keeps flashing now cannot se... [Read more]

Gardtec 300, how to remove sensor for decorating ?

Gardtec 300 Sensors are screwed to wall. I need to open sensor to remove to allow decorating. How can I disabl... [Read more]

I have a error code C2?

I have an error code C2 and red light (fault). When I put my code in sometime it come up with a fault with cod... [Read more]

how to change code?

how to change the code in a veriteas 8 , tried the instrutions but they dont work . zone lights dont flash aft... [Read more]

does a citadel xri have two battery's?

Does a citadel xri have battery in the outside box?

stopping my alarm sounding when i;m trying to set it?

following a power outtage ihad to follow the above process of resetting the alarm code from 1234 to my own per... [Read more]

accenta G4 mini, nearby lightning strike?

panel reads PA FAULT LOCKOUT I have tried shorting SET and left PA socket but panel returns to PA Fault etc th... [Read more]

Gartec 300 tamper light flashing?

Cant get the tamper enter light to stop flashing, had a power cut and has been flashing ever since.

omega5+ panel?

Can a honeywell AG6 bellbox be connected to a omega5 panel somehow, even if it means doing away with tamper ci... [Read more]

ef/door contact problems on scantronic 9800?

Hello can anyone advise please - I have a scantronic 9800 alarm system and it developed a fault just before Ch... [Read more]

accenta gen4 blowing fuse?

Hello I've the above alarm fitted some years ago now that has started to blow the keypad fuse when the battery... [Read more]

Vertias 8C?

Have a Vertias 8C installed for many years While away on holidays friend entered house and forgot code :) So... [Read more]