Mend > Home Alarm Systems

2

we have an veritas 8 flashing power light?

we have an veritas 8 we had our fuse box relplacesed to day and now our power light is flashing it normally is... [Read more]

1

Replacement keypad for optima xm?

I need a replacement key pad for the obsolete optima xm. The numbers have worn away on the rubber pads. Does a... [Read more]

1

how do i turn off my veritas alarm when the code wont work?

we tested our veritas alarm, after just moving in, but now it wont stop and the code is not accepted, how do w... [Read more]

4

veritas R8?

I need instalation manual for above manual to reset + reprogram system

1

resetting low battery warning?

I have ADT TC1555 system. The trouble light says low battery. I have changed all of the batteries, and it is s... [Read more]

2

i have a accenta 8 alarm?

i need to reset the exit and entery delay on my home alarm but have no insruction manual for it... basicaly i ... [Read more]

3

I think I need a new battery for Veritas R8?

My alarm (Veritas R8) went off for no reason. I was in the house at the time-so alarm was not on. I set the co... [Read more]

2

Optima, Alarm going off whenever there is a mains failure?

I have an optima XM alarm system that has worked well for several years. Recently if it is set and there is a ... [Read more]

2

Accenta alarm, cannot set system?

Hi, I cut through the cable that was wired to magnetic sensors on exterior doors. This had been disconnected ... [Read more]

1

Veritas 8 Compact alarm?

Bell and stobe not working on outside box after a series of power cuts, 24 hr light is on on the control panel... [Read more]

2

zone 8 light won't go out on veritas?

since we have had the floods my alarm has been stuck on zone 8. when i try to put my code in or press any othe... [Read more]

2

Keypad locked after a thunderstorm?

After a thunderstorm my alarm went off. Its an Accenta Mini 8. Now both keypads are locked up and I cannot r... [Read more]

3

Replacing battery pack Veritas R8?

My alarm has started intermediately bleeping/humming during the night more noticable from the outside, I've ch... [Read more]

1

magnetic door contacts ?????

is there a door contact that will fit a molded upvc door edge or a product that will allow a standared door co... [Read more]

5

why has the tamper light come on?

I have an accenta 6 alarm, and for no reason the tamper warning light has come on. on the panel it says refer ... [Read more]

5

Veritas Strobe outside?

I have a Veritas alarm system and when the alarm is activated or when i do a test on the system to check PIRs ... [Read more]

1

what is a code 66?

i have a gardetec 300/500 series. just moved in and the alarm panel says 66 on screen. power light is on pane... [Read more]

3

Alarm Bell.Co system reset?

I have just moved into a new property and it has an Alarm Bell.co alarm system fitted, the previous owner ref... [Read more]

3

SCANTRONIC 9600 ALARM?

I PURCHASED A SCANTRONIC 9600 ALARM SYSTEM ON EBAY BUT HAVE NO WIRING INSTRUCTIONS WITH IT OR OPERATING INSTRU... [Read more]

2

Accenta Alarm?

I have recently just added on 2 additional zones into my existing system but they seem to have been omitted by... [Read more]