How to mend ... Zone 8 Fault

Optima 2+?

My Alarm started to develop a fault about 6 months ago where it would activate even when it wasn't set? At the... [Read more]

worcester 24i combi20-30 minute delay between demand and ignition?

I have a worcester 24i providing central heating and indirect heat to the hot water tank in a sealed system co... [Read more]

how can i fix my scantronic 9448+?

i have an intermittent fault on the tamper circuit, a local engineer has checked the system but was unable to ... [Read more]

Baumatic Induction Hob Residual Heat Indicator Fault?

On one of my hot zones the "H" indicator (for residual heat) remain on all the time even when the hob is not b... [Read more]

Strange timer fault on Halstead Best 50?

I have a Halstead Best 50 which works fine on HW timer but does not work on CH timer. If I switch to continous... [Read more]

9827 Key Pad fault code 6F?

Alarm disabled during the day and went off twice showing 6F as the code, turned alarm off both times with secu... [Read more]

my house alarm wont arm because my panic alarm wont work?

my alarm went off 2 nights ago for no reason but a zone was flashing on the alarm itself. today my panic alar... [Read more]

Scantronic 9448+ Alarm Sounds on exit?

I have reset my alarm due to replacing an internal fuse - after a bit of searching for the fault! Engineers w... [Read more]

Intruder alarm system Optima G3 omit fault?

Any idea why this system should go into full alarm when a zone has been omitted (ie at night) but never when ... [Read more]

all zone lights are red when trying to arm? ?

My alarm will not arm. The zone lights are all red as if a fault but with every zone??

how can i fix my optima xl6 intruder alarm?

occasionnially my alarm goes off in the same zone so we have started to omit this zone but this morning after ... [Read more]

Scantronic 9800 c4 fault?

Can anybody please help with a c4 fault code that has appeared on my Scantronic 9800 Alarm. I can see that it... [Read more]

Whats it the problem with my veritas R8?

when i turn on the lights in the house the panel activates a tamper fault on zone 3 & 4. This isnt everytime b... [Read more]

chime fault? in accenta/optima g3 alarm panel?

I have tried to increase the volume on the door chime in the day mode unset in the accenta g3 panel. The panel... [Read more]

I have a fault on my system?

I have just moved a door contact and the system will not reset from engineer mode. the keypad says "zone flt" ... [Read more]

ACCENTA 8 - Door entry problem?

Hi, Our Accenta8 system has just started doing an odd thing. All aspects of the system work fine accept one ... [Read more]

veritas R8 - gone off, tamper light on, code not accepted......HELP!!!!?

Early this morning my veritas r8plus system went off after a power fault. Entered code, would not stop. Trie... [Read more]

System fault , zone remains open?

Hi I have a NAPCO GEM P1632 Control Panel with two GEM RP1CAe2 keypads. The overhead garage door zone remains ... [Read more]

citroen c5 bi-zone air con fault?

passenger side works as it should, but drivers side will only produce cool air.

Veritas R8 alarm- zones 'in fault'? Continued?

I'm hoping to receive a response from Death, who answered my last question about my Veritas R8 alarm being in ... [Read more]