How to mend ... Problem Replaced Battery

Control Panel flashing Rf problem?

My eight year old Scantronic 500r+ free wire alarm with four 515r PIRs have never given any problems until rec... [Read more]

Flashing power light on Veritas 8C?

Have a vertias 8C alarm which has worked fine for years. Recently the whole alarm, panel etc went dead, no li... [Read more]

Could the NVM chip be dead after 13 years?

I put my system into engineers mode (0xxxx then opened panel, E displayed). This was to allow me to disconnect... [Read more]

fault with veritas 8c?

in my garage i have a texecom veritas 8c panel with a rkp at the front of the garage i hate two sensors 2 door... [Read more]

Home Alarm System?

I've just replaced the Remote Keypad 8EP416 (possibly 8EP219 it's about 12 years old) with Gen 3/4 Accenta LED... [Read more]

My Accenta 8 alarm bell sounds as soon as I open my front door?

I have Accenta 8 Home Alarm System and replaced the internal battery recently. Did the reset procedure and no... [Read more]

Eurosec CP8L House Alarm problems?

We have a 3 year old Eurosec CP8L House Alarm that has recently over the last few weeks been causing us proble... [Read more]

How can I fix my house intruder alarm?

8 years ago a Compact SL8 intruder alarm (very basic key pad) was fitted. Internal battery Texecom 12V 2.1 amp... [Read more]

had power failure now alarm not working?

neighbour cut electric power to my house while working on his drive. i had no electric for 5 hours. my alarm w... [Read more]

VERITAS 8 ALARM FAULT?

I was moving one of the PIR sensors in the romm when all of a sudden it stopped working, no light or nothing, ... [Read more]

Optimax XM6 untruder alarm - can I repair?

My Optimax XM6 seems to have seized up it will not respond to any buttons being pressed at all, it does not ev... [Read more]

Veritas 8 Alarm System - when off when not set?

Last night the alarm went off, even though it wasn't set. The alarm would not deactivate from either key pads.... [Read more]

vertias 8 alarm went off when not on?

Last night the alarm went off, even though it wasn't set. The alarm would not deactivate from either key pads... [Read more]

problem with scantronic 9448?

hi guys installed this panel approx 15 yrs ago replaced a pir 10 yrs ago as it had gone dead.recently another... [Read more]

Scantronic 9448 tamper fault?

During a recent power-cut the alarm system failed with a tamper fault. the key-pad wasn't illuminated and I wa... [Read more]

Replacing battery on Scantronic 9448 system?

During a recent power-cut the alarm system failed with a tamper fault. the key-pad wasn't illuminated and I wa... [Read more]

Why does my Optima XM alarm's internal bell keep going off?

Wondered if anyone could advise. Last year my Optima XM alarm started playing up. The internal alarm kept goin... [Read more]

How can I remove a tamper lockout on my Optima XM6 keypad ?

Over recent years our alarm has sounded whenever mains power is restored after a powercut. Although a bit of a... [Read more]

I can't fix my Napco MA-900 system?

I have a Napco ma-900 system that was working fine. I armed the system went to bed ,and in the morning could n... [Read more]

alarm goes off by itself aprrox. same time every morning?

i replaced my battery ... i put my alarm on so that it will go off immediately if any door or window is opened... [Read more]