How to mend ... Engineers Mode 8

do i need to enter engineers code to dis-connect external bell box and repl?

hello need some advice, have tested bell-box which has a supply present from alarm panel of 12v d.c,the o/s so... [Read more]

Could the NVM chip be dead after 13 years?

I put my system into engineers mode (0xxxx then opened panel, E displayed). This was to allow me to disconnect... [Read more]

Veritas R8 alarm query?

Hi, my alarm has been installed for 15 years and have had no problems. The installing company is now defunct. ... [Read more]

Zanussi WJS1665W Washer Dryer - Error Code E52 - help?

I am running the Engineers Diagnostic mode & gtting this error code - E52. I have seen that this may be "no... [Read more]

Itec horizon alarm panel?

With my limited knowledge, I put in engineers code 1191 to open control panel to change battery. This worked o... [Read more]

Optima accenta g3 system locked, panel shut down?

I was removing a PIR sensor from the wall when decorating and set the tamper off a few times whilst removing/r... [Read more]

How to fix Zanussi ZWD 1271W stopping at beginning of any program?

My Zanussi ZWD 1271W when on any wash program will fill with a bit of water as normal, spin one way then the o... [Read more]

Ariston Microgenus 27 MFFI?

Help! Noone can fix my boiler. it has a mind of it's own. It comes on when it likes and switches off when i... [Read more]

potterton performer 24kw HEcombi?

Hello ,is there any quallified heating engineers out there who may know wat this fault is. no hot water,the p... [Read more]

Accenta G4 setup?

After installing this unit which seemed to go ok and in the Engineers mode it appears to sound the alarm, oper... [Read more]

Zanussi Washer/Dryer WJS1665W - E73 Fault Code?

I have been slowly narrowing down a problem with the Drying function on my Zanussi Washer / Dryer. Basically ... [Read more]

veritas keypad in tamper mode cant reset system?

veritas keypad has been opened and repositioned but now in tamper mode cant reset or access system is there a ... [Read more]

Programming Veritas Alarm?

I have a veritas R8 and when I try to enter programming mode for bell test and the like I get a single tone an... [Read more]

Gardtec 300 - maintenace mode?

I need to turn the mains off for 30 mins or so but the alarm will of course go off for about 20 mins. Is there... [Read more]

accenta mini G3 , strbe keeps flashing?

I moved a PIR to decorate then came out of engineers mode since which the strobe has continued to flash (not a... [Read more]

Vokera Maxin 24e Lockout?

I am having problems with the Lockout Reset Button illuminating intermittently on my Vokera Maxin 24e, the con... [Read more]

optima xm: can i change zone configuration in engineers mode without activa?

Have recently inherited an Optima XM system but now wish to make changes to the programmed zone configuration ... [Read more]

Optima XM6?

my optima xm6 system was on a twelve month contract, but the engineer has now ceased to trade and will not att... [Read more]

How can I set an exit time?

The system is an Optima Plus Working fine until I removed the mains fuse, then unable to set an exit time. W... [Read more]

Baxi 105e c/htg cuts out of its own accord?

No problem on hot water. C/htg does not cut in if temp lights display a high temp. To get the boiler running... [Read more]