How to mend ... Keeps Setting Off

Hotpoint wma 33?

Hi my machine does not spin anymore,it goes through the cycles but fails when it reaches the spin setting.does... [Read more]

Cannot get Scantronic 9651 to set on exit?

I put the code in, press A and there is a long constant tone. The panel says "setting A" or similar. I close... [Read more]

Veritas 8 home house alarm?

During house extension alarm cable was cut, system powered off and cable repaired, battery good charge.Now sys... [Read more]

alter exit timer?

How do I alter the length of time we can exit the house after setting the alarm

veritas alarn r8 plus setting when powered up ?

veritas alarm r8 plus with key pad ,the panel was bleeping intermittantly so i messed about with the codes .t... [Read more]

How to reprogramme scantronic 9427?

Security system has defaulted to manufactures setting after powercut. My security code is not working. Could a... [Read more]

Keypad dislodged from the housing setting off the tamper alarm?

Hi my keypad became dislodged from the housing, on carefully fitting it back on the tamper sensor was set off.... [Read more]

Can the main cable be spliced on my Accenta G4?

My joiner cut through the alarm cable with his stanley knife. I spliced the cable, but can only get so far whe... [Read more]

how to re set or fix my accenta g3 alarm?

when i set my alarm by entering the four digit code zones 1 and zone 4 light up my alarm beeps to set like nor... [Read more]

Alarm system fault?

I've installed an additional zone which consists of 3 door contacts. Since installing the new zone i'm unable ... [Read more]

Accenta 8 Mini Alarm code change?

Despite following the instructions the system will not activate and we now have no working alarm system - coul... [Read more]

Fault with Scantronic 9752 (Cant stop alarm after setting off alarm)?

Hi, I have a scantronic 9752 and when the alarm is tripped by any means I can reset the control panel but can... [Read more]

Access to Optima G3 ?

Hello I want to fit extra PIR's (2) to my installed Optima. However, I'm unsure about gaining access to the p... [Read more]

i have micromark house alarm mm23207 reset ?

how to change times allowed from setting the alarm and deactivating it or re-entering my home

Faulty alarm?

My alarm not always but occasionally keeps beeping after setting. the alarm is then triggered to go off

Galax8 8 Reset After Setting Off Alarm?

Hi all. i have an ADT alarm with a Galaxy 8 keypad, this alarmed was monitored by ADT for 5 years, but, due t... [Read more]

a/ external box has no sound when alarm is setoff?

b/ when part setting the keypad does not bleep and the alarm does not go off once activated. only info on sys... [Read more]

zone open message?

First time setting up SCANTRONIC 9651. I have programmed zones 2,3,4,5,6,7,8 as not used. When come to set it ... [Read more]

Veritas Excel Alarm?

I have a Texecom Excel Alarm in a flat. It is a basic set up with 4 room sensors and 1 exit door contact and w... [Read more]

Control Panel flashing Rf problem?

My eight year old Scantronic 500r+ free wire alarm with four 515r PIRs have never given any problems until rec... [Read more]