During house extension alarm cable was cut, system powered off and cable repaired, battery good charge.Now system has reverted to factory set code but problem is that after full setting system exit tone sounds as normal but when it times out the alarm is activated although no zone lights illuminate. Tamper not a problem.
Very strange no lights if it has gone to default check your zone setup also your memmory log. If the keypad is working the system has to show some lights on it recheck your repaired cable think you may find some cores mixed up.
Jimmy
May 2012
Automatic Answer
We may have found other answers which could help you.
howtomendit.com for free repair help, information and advice.
