Mend > Chainsaws

6

homelite chainsaw fuel lines replaced?

My homelite 45cc 18" chainsaw fuel lines, filter and primer bulb were replaced. After priming, the saw will r... [Read more]

1

How do you route a fuel line that has only one inlet in the carburetor?

I have a 1983 Craftman Poulan saw. The fuel line was rotted when I took it off. I can not figure out how to ro... [Read more]

1

How do I adjust the idle on my Stihl 028 AV?

carb has been overhauled and wants to bog down at high speed.

1

chainsaw chain upside down?

is it possible that the chain could be on upside down? looks like the little teeth are on the inside

2

husqvarna 41 dies @ idle?

Dear tech, After leaving my saw in the weather I replaced my ignition and it started right up. However it wi... [Read more]

5

Tarus 4500 chainsaw?

i have a tarus T4500 chainsaw for which i need a tensioner bar and nut where can i purchase

1

chain saw -?

The saw in a Performance PWR1700CSB. The chain stops when contacting the wood. I have replaced the chain and i... [Read more]

2

How can I fix Partner 351 chainsaw starting problem?

I have had chainsaw about 5 years. With choke on and fully primed it will occasionally start and then stop. ... [Read more]

1

how to set idle low side 041 stile?

got saw idle needs set on low side need start point just got this saw .need base someone got all wacked out

1

how do I remove sprocket on 009 stihl?

odd clips holding clutch shoes in around nut I assume I must remove to change sprocket. how do I remove these ... [Read more]

2

Gas / Oil Mix Ratio?

Gas Oil Mix Ratio for Poulan 3200 20" Chainsaw

3

Fuel Mix?

what fuel mix (25:1) or (50:1) for a 38cc McCulloch chainsaw

1

Homelite Timberman 25?

My machine won't start. I put in new gas, cleaned the airfilter, and nothing...what can I do. Thanks

1

how do you wrap the rope?

how do you wrap the rope around the starter spindle, which direction?

1

carb. adjusting tool?

My poulan chain saw runs well but will not idle without turning the throttle adj. up to the point where the ... [Read more]

1

CHAIN LENGTH?

I HAVE A GARDENLINE PETROL CHAINSAW GPCS-42cc OREGONdouble gard 91 MY CHAIN IS WORN TOO REPLACE IT WHAT LE... [Read more]

1

how can i fix this problem?

i have apoulan 3314 saw . it revs up but dies like it is starving for fuel

1

homelitechainsaw3314?

chainbrakeonunitnotreleasingchainunlessyoupullbrakereleasehandlebackwithforcetowardsgrabhandle

1

spark plug gap?

What is the spark plug gap on a Mcullouh min mac 35

3

Why does my chainsaw only runs when choked?

what would be a solution? when i take it off of choke it idles up and dies.