Recent: Pro clm 1500 tss table saw?

Mend Homelite 45cc 18" Chainsaws

Mend Garden Tools, Chainsaws
Find out how to mend it for free.
Ask Question
Mend Garden Tools, Chainsaws
Mend repair fix Homelite 45cc 18" chainsaws

Mend chainsaws ...

Mend Garden Tools, Chainsaws

32-36508?

what does center clip go against
Mend homelite chain plug

Need age and parts for homelite?

I have a homelite textron UT 10618a serial number 7F1601385. I was hoping someone could help figure out what y... [Read more]
Mend Garden Tools, Chainsaws

McCulloch Power Mac 310?

McCulloch Power Mac 310 ignition coil p/n 216599 (223706-1). Where to find?
Mend Garden Tools, Chainsaws
1

Xh2xs.0454ra?

Replacement chain XH2XS.0454RA
Mend spark carb air
1

Chainsaw missing gasket & plug gap?

pwr33cccsa chainsaw spark plug gap? Is there a gasket between carb and air filter plastic housing?
Mend Chainsaws

Mend > Chainsaws

Mend Homelite 45cc 18" Chainsaw Carburetor Fuel Lines

homelite chainsaw fuel lines replaced?

My homelite 45cc 18" chainsaw fuel lines, filter and primer bulb were replaced. After priming, the saw will run until the gas pumped in from the priming is gone; It will only stay cranked long enough to burn the gas from priming. Can anyone give me some advice on what to check?

limbs down
November 2008
HomeliteHomelite 45cc 18"Garden Tools, ChainsawsChainsaw Carburetor Fuel Lines
try changing the priming bulb pipes over, as the priming bulb sucks fuel up the pipe that goes from tank to the carb then through the priming bulb back to tank in that direction.

armyof1
July 2009
If the main line is clear, you'll probably need to clean out the carburetor, which will likely require a diaphragm/gasket kit. Many sites carry them. You probably have a Walbro carburetor. Just google "Walbro carburetor kit".

Jack
December 2008
I have replaced all the fuel lines (they were rotted out) and the prefilter; now it does start each time I prime it, But after priming gas has burned it dies. Its as if I can only get gas in the carb from priming but it will not flow otherwise.

down limbs continue
November 2008
I have replaced all the fuel lines (they were rotted out) and the prefilter; now it does start each time I prime it, But after priming gas has burned it dies. Its as if I can only get gas in the carb from priming but it will not flow otherwise.

down limbs continue
November 2008
sounds like one of the lines has a crack in it or has come off of the carb

pat
November 2008
check the main fuel line that runs from the tank to the carby and little filter inside carby could be blocked

frail
November 2008
Mend Garden Tools, Chainsaws
Mend repair fix Homelite 45cc 18" chainsaws
Mend chainsaw carb homelite

How do I attach the proper fuel line from tank to carb?
Mend using wrong gas

using wrong gas?
Mend choke runs throttle

how can i fix my homelite super 2 chainsaw?
Mend chainsaw Homelite repair

how to put a fuel line on a homelite chainsaw XL 101?
Mend cools running warm

homlite ut10532 quits when warmed up and starts when it cools ?
Mend chainsaw parts Homelite

Where can I get parts for Homelite XL?
Mend chainsaw repair homelite

How can I get the primer bulb to pop back up for the next "pump"?
Mend chainsaw homelite textron

oil for chainsaw?
Mend carburetor adjustment screws

Carburetor adjustment screw access?
Mend remove primer bulb

homelite mighty lite blower 26cc?
Mend chainsaw carburetor homelite

Carb: Adjustments?
Mend homelite 2 chain saw

homelite 2 chain saw ?

Other models...

Homelite 26SSHomelite 360SLHomelite 42Homelite 44ccHomelite Mighty Lite 26ccHomelite Ranger Powerstroke 33ccHomelite UT10617Homelite UT18022Homelite XH2XS 0454RAHomelite XL 700Homelite XL-101Homelite XL-105074

How to mend ...

Find out how to mend just about anything howtomendit.com for free repair help, information and advice.

Related Categories

Mend Grass Trimmers
Grass Trimmers
Mend Hedge Trimmers
Hedge Trimmers
Mend Irrigation Systems
Irrigation Systems
Mend Lawn Mowers
Lawn Mowers

Mend Garden Tools, Chainsaws
Mend repair fix Homelite 45cc 18" chainsaws