Mend > Chainsaws

my chainsaw wont start?

i accidently used straight gas without oil mix and ran it till the fuel ran out. and now it wont start. do you... [Read more]

carby adjustment on talon blower ab3201...32ccpetrol?

how to adjust carburetor on Talon blower vacuum ...the high air screw...and the low air mixer screw and finall... [Read more]

McCullogh timberbear ignition problem/question?

I recently installed a new 605 shortblock in a Mac Timberbear. I tested the spark before completing the assem... [Read more]

can't start ms180 sthil chainaw?

brand new sthil ms180.v hard 2 start on first 2 uses now can't start a all. even change spark plug! followed s... [Read more]

Poulan engine rebuilding spec ?

I have a Poulan chainsaw that will not start. I believe the piston is damaged and I need to replace the cyclin... [Read more]

Taking apart a 330 Homelite Saw?

I have all the exposed screws and bolts out of the body of the saw and still can't get the saw apart. It apear... [Read more]

I need a chain and drive gear for my 116si dolmar chainsaw?

I am trying to find some one to supply me with a chain and drive gear for my dolmar 116si chainsaw can you he... [Read more]

Help with Homolite 330 saw reving high?

Homolite 330 saw revs very very high and does not seem to respond to any settings. It ran very well up to the ... [Read more]

How can I fix a Homelite XL@?

I am trying to fix an older Homelite XL2 for a young lady. I am putting in a new set of points but can't seem ... [Read more]

STIHL 017 CHAINSAW REPLACEMENT CHAIN WILL NOT TURN?

I have just replaced the chain on my Stihl 017 petrol chainsaw by following the instructions & all seemed well... [Read more]

reassembling handle on stihl chain saw model#MS200T?

I cannot figure out how or where the cut off switch goes or where it is positioned in the handle before reasse... [Read more]

what is the plug gap for a homelite xl? the plug is dj7j?

I have an old Homelite XL Chainsaw and need to change spark plug. The plug is a Champion DJ7J. What is the p... [Read more]

Does anyone make a carbide chainsaw blade ?

If there is such a blade, where can I purchace one.

How can I fix my craftman chain saw mod. 358.351160 . 20 inch blade?

How do I replace fuel lines to the fuel tank? There are two lines. One line is connected to the carburetor and... [Read more]

My poulan pro 295 will not rev up?

I have a poulan pro 295 and it will start and run at low RPM but dies at idle and misses or chokes up when I ... [Read more]

RYOBI Petrol Chainsaw PCN 4545?

The Brake stays on when handle lifted, have to pull it up slightly more manually in order for the chain to rot... [Read more]

chainsaw starter rope?

the starter rope won't pull smoothly, it's very jerky and so can't get a good pull on it to start engine. it s... [Read more]

Carburetur adjustments for Homelitexl chainsaw?

What is the proper adjustment for the three carburetur screws on my Homelite xL Chainsaw

fuel lines for poulan 2150 chain saw?

where can i find a diagram of where my fuel lines connect to caruretor, primer buld & fuel tank

Mac 441 - oil to gas ratio?

I urgently need to know the correct oil / gas ratio for the Mac 441 chainsaw. If possible it would appreciate... [Read more]