STIHL 017 CHAINSAW REPLACEMENT CHAIN WILL NOT TURN?
I have just replaced the chain on my Stihl 017 petrol chainsaw by following the instructions & all seemed well but the chain does not turn - I thought it was probably debris jammed in the bar preventing smooth movement so I soaked it in chain lubricant & tested it again but to no avail!! Could it be the bar that is damaged??? Or can anyone advise me on the possible cause of this as its driving me nuts - there is still plenty of oil getting through to the chain so it is certainly not lack of lubricant!!
Your help would be greatly appreciated.
Simi
It sounds like a goofy reason, but check to make sure the chain isn't on backwards.
Don
December 2009
You either have a bad bar or a bad sprocket tip on the end. If you purchased the wrong size chain that would be a problem also.
Larry Holbrook
September 2008
If you still have the old chain check the thickness of the drivers with the new chains drivers . The drivers are the part of the chain that rides down in the bar. The rails have to match the chain drivers.. to tight on the rails and the chain won't turn to loose and it won't cut straight. Most bars are stamped with the correct chain dimensions.
kj
December 2007
ANOTHER POSSIBILITY IS SOME OF THE BARS HAVE A ROTATING GEAR IN THE TIP OF THE BAR IF THIS IS FROZEN NOTHING WILL TURN EITHER
dhagan@hotmail.com
December 2007
Are you sure the chain brake handle hasn't been pushed forward - locking the chain clutch? If this isn't the case then either the wrong chain has been fitted or its well over tightened - or the chain bar is out of alignment somehow.
John
December 2007
I can answer this question...
STIHL 017 CHAINSAW REPLACEMENT CHAIN WILL NOT TURN?
howtomendit.com for free repair help, information and advice.
Try fixfault.com to fix chainsaws.