Mend > Home Alarm Systems

How can I fix my 9427 alarm?

iv had new windows and front door fitted. We have had the house for a year. We have no instructions and the do... [Read more]

I have a flashing green light on my veritas r8 control panel?

This green light is flashing on both panel and box how can I sort it out coz I'm worried now I can't use the a... [Read more]

How can I fix my viritas alarm not sure of no. but oldish?

The window alarm was set off after the cat touched it. I put in my code and pressed reset. the amber light at ... [Read more]

Temp Removal of alarm box to decorate?

Hi, I have a Accenta 8 mini working alarm with adjacent keypad. I need to loosen from the wall to enable me to... [Read more]

alarm replacements ?

I have a scantronic 9800 I had this installed years and years ago I believe its time the batteries were replac... [Read more]

How do I change the batteries in the PIR sensors for I-on16 alarm?

I need to change the batteries in the PIR sensors but when I try to remove the front of the sensor it sets the... [Read more]

altex alarm reset?

i have bought a house and dont have the alarm code how do i reset the alarm please

problem with texecom oddysey tamper ?

hi guys,Im having a bit of trouble with the above, basically i have connected 2 bellboxes( texecom oddysey 3) ... [Read more]

Home Alarm TS790 how to reposition a PIR?

How to isolate a individual room PIR in order to reposition it without activation of anti tamper alarm.

paragon plus no audible beeps from keypad?

Lodged previously as an answer; should have been a question, as follows: My Paragon Plus house alarm has stop... [Read more]

300/500 series alarm?

My alarm system has developed a fault I thought it was the battery (dated 2011)which I have now renewed but th... [Read more]

How to fix faulty number pad digits ?

I have a Micromark mm23244 alarm and the numbers 1,2 and 3 on the code pad don't work anymore. Can you tell me... [Read more]

Scantronic 9827 alarm keypad?

Hi. I have replaced a 9800 keypad (on a 9800 control panel) with a 9827 keypad for someone as some of the old ... [Read more]

9448+ panel problem?

The panel has been powered down, as a continuous tamper fault is occuring. I have linked out the A/T termina... [Read more]

9200 alarm problem?

Power green light, day,zone 1 & zone 2 all red lights on. Gives off a constant tone. I need to reset the alarm... [Read more]

Verista alarm plebes for two minutes?

My verista alarm plebes for two minutes every time the front door opens. It stops after that. The actual alar... [Read more]

Turning power off to scantronic 9427?

I need to change electric sockets in my house but when I turn the power off at the switch board to do this the... [Read more]

9449 - no power?

Hi I have a Scantronic 9449 (with 9427 keypad), I think the alarm went off once and then the blue strobe kep... [Read more]

How can I reset a 9827 control pad?

Hi how do I reset a 9827 control pad after changing the main Box battery. Control pad is showing a constant re... [Read more]

9651 Alarm Beeps on hard wired panel?

The double conformation bleeps have stopped working when setting the alarm, we have had it installed about 4 y... [Read more]