Mend > Home Alarm Systems

Intermittent chiming from control panel when alarm is not set?

Does anyone know why the chiming sound happens when the alarm is NOT set? I enter pass code and the number 6 a... [Read more]

9800 rkp diodes?

Hello all,hope you don't find this question stupid!. Both diodes have failed,red one some years ago and now t... [Read more]

reset keypad tamper?

scantronic 9651 alarm hoe to reset keypad 9641 tamper

Battery replacement?

Hi I recently had to replace my alarm battery,but when I removed the lid on the main unit the installation man... [Read more]

The carpet fitter has cut the cable?

The carpet fitter has cut the cable for the keypad and we can't stop the interior alarm.Please help me fix it.

Gardtec 800 with a battery/fuse failure?

My Gardtec 800 house alarm system has developed a fault over the last 3 months. External and internal alarms ... [Read more]

Alarm is beeping 10 times when we try to set alarm?

Why is our alarm beeping 10 times when we try to set it. We don't know which zones are for which room. Lin... [Read more]

Optima XL 4 tamper?

The tamper and attack lights have been coming up for the last week or so.I have stopped using it now because t... [Read more]

How do I view a manual, ?

How do I view a manual, I downloaded as instructed and got adverts

e manno?

am sorry mate, but peccavi if I took any notice of him, would would annoy me very much,just read some of h... [Read more]

scantronic alarm?

i keep getting zone 3 programmed but not learnt can anyone help

Alarm sounding after mains power restored?

Accenta G3 panel. After a short power failure the alarm goes off when mains power is restored, is this expect... [Read more]

Zone fault?

When I put on my alarm zone 1 light stays on,which is the window contacts,how can I reset it to work with the ... [Read more]

Why is the red power light flashing on the wall keypad?

I have had my alarm system in full working order since installed in 2007, but since a couple of weeks ago i ha... [Read more]

Remote Key Pad (RKP) disabled after Tamper reset (Accenta G3)?

Hi, I removed the cover from my RKP having mistakenly thought it was making a beeping noise (don't ask plea... [Read more]

tamper light will not go out after reset try set alarm it show on and will ?

the tamper light stays on when setting alarm. tried to reset light gose out but one of the light comes on and... [Read more]

e monno & gts?

Hello again....I only have limited Internet access at the moment, the sound bomb has been wired following the... [Read more]

Troubl light is on?

I have an Ranger American alarm system that 7 years old. We have never used it as an alarm system, but it is o... [Read more]

Mains driven siren?

Hello all, Iam trying to fit the sound bomb to my existing ADE accenta. I have wired up the AC~ but iam ha... [Read more]

hot to connect a deltabell plus to a scantronic 9200 panel?

I am trying to connect a scantronic 9200 panel ( very old!) To a pyronix deltabell plus. A bit confused, ho... [Read more]