Mend > Washing Machines

Mend Fisher & Paykel Intuitive Water Fill

Access to water line?

How do I access and remove the rubber right angle boot connected to the fill nozzle on a Fisher Paykel Intuitive washer? Can't figure out how to raise/remove the top section.

Dave
June 2014

Fisher & Paykel Fisher & Paykel Intuitive Household Appliances, Washing Machines Water Fill Fisher

You have been given wrong info by other poster. They are obviously not familiar with F&P washing machines. To lift the top, Unplug machine from power. Remove the lid by pulling up on one side. Then remove the 2 plastic plugs at front of top deck. Under the plugs is 2 screws. Remove them. Then on the back of the top panel there is a clip on each side which locks top deck to the body. Prise them out with a flat screwdriver and pull up deck to free it. Then swivel top deck up and back. You can't take it right off because of wiring so get someone to hold it up while you work on the inlet. Watch out for out of balance lever at right rear as you lift the top up. You don't want to break it.

Lincoln Appliance NZ
June 2014

Top might be removed by stiff inch and a half putty knife. Find four spring steel clips by feel, sliding p k around perimeter slot. Push and pry up at the same time using a second p k with duct tape on both sides to avoid marring finish . Good luck Jim . If any of your I M force............

Jon Fran
June 2014