Recent: Safely remove screen protector from a Macbook Air?

Mend > Document Laminators

Mend Royal Sovereign Ultima 65 Rollers

Stop button wont work on Ultima 65 laminator?

When I switch on my Ultima 65 laminator the rollers are turning and wont stop, the stop button wont work.

Kate
July 2012
I repair these machines for a living around pittsburgh pa. The most likely cause of your problem is a bad membrame switch. its in the control panel. it also causes the pushed forward button machine ran backwards. the switch is easily replaced, costs under 20 bucks and while you have it apart clean the board contacts with electrical contact cleaner

feel free to call me, telephone help is always free

bob haller service and sales pittsburgh pa 412 366 4906
July 2012

Automatic Answer

We may have found other answers which could help you.

Click here for Ultima 65 Rollers

Related Questions ...

Mend laminator rollers gbc ultima 65
1

GBC Ultima 65 rollers just arollin' nonstop?

Help. I have a GBC Ultima 65 which turns on, but the rollers immediatly run. The control panel seems ok, i l... [Read more]
Mend hot s burning
1

GBC Ultima 65 Smells Hot, Like It's Burning?

I've Cleaned the Residue From the Ends of the Heat Rollers and Users Say It Still Smells. They have theorized... [Read more]
Mend gbc 65 heat
1

our GBC Ultima 65 control panel is not on?

Our GBC Ultima 65 control panel is not on. The laminate frolled into the heat rollers and the control panel ... [Read more]
Mend gbc ultima 65 laminator
2

GBC Ultima 65 Laminator?

Laminator runs fine for about 2-3 feet of lamination, then just stops-power is on, heat is on, rollers just st... [Read more]
Mend laminator heat gbc
1

Ultima 65 laminator heat up but does not run when button is pushed?

Our GBC ultima 65 laminator turns on and heats up. When the heat indicator shows that it is ready, I push the... [Read more]
Mend gbc ultima rollers
1

How do I remove the film rolls from the GBC Ultima 65?

I have trouble EVERY time taking the film rollers off and putting back on, especially on the bottom. Everyone ... [Read more]
Mend How to mend it?
1

GBC Ultima 65 - new rollers needed!!?

I am reading Bob Haller's info about these laminators. I work in a public school in East San Diego County (Pin... [Read more]
Mend film rollers 65
1

How do clear a jam of rolled up film on the exiting rollers?

I have a new Ultima 65 and various occassions it starts rolling the film on the exit rollers of the machines a... [Read more]
Mend heating rollers help
1

laminator ultima 65 is not heating?

The rollers just get warm. Thank you for any help
Mend gbc 65 film
1

GBC 65 Ultima is getting a roll around on the front lower roller. ?

This was following a major roll around on the back roller. Now after threading film I am xonsistently getting ... [Read more]
Mend hot years replaced
1

gbc ultima 65?

Our laminator does not seem to get as hot on one end as the other. It has been this way since it was new. (sev... [Read more]

How to mend ...

Find out how to mend just about anything howtomendit.com for free repair help, information and advice.
Mend Document Laminators ...