Simpson EziSet 550 how do you adjust the fill control?

simpson eziset 550.
any one knows how to rest the the machine after changing the main board?
many thanks in advance.
ray

ray
April 2010

i am having the same problem...mine also will not drain. Both problem are temperamental though, sometimes it will get through a cycle normally

Ang
November 2009

The water level sensor is not adjustable by the home handyman. The pressure tube from the bowl up to the sensor may be blocked but that would normally result in overflow most if not all the time. More likely to be a faulty inlet valve not shutting off. Check by lifting the lid during fill several times. Water should shut off immediately lid is lifted or start/pause is pressed. If it hesitates for a few seconds or does not stop then change the inlet valve.

Lincoln Appliance NZ
October 2009