How to mend ... Pir Despite Set

changing entry/exit zone on 9448es with 9427 keypad?

basically it looks as if the entry/exit zone is set on my kithen pir as the previous owner used the back door ... [Read more]

help plz?

hi there i added a new pir motion detector replacing an old one, and the detector was playing up, is this the ... [Read more]

Tamper flashing & cant set system?

Veritas 8 system. had to open pir to paint around, b4 opening entered engineer code and then entered 00 which ... [Read more]

how do I set the zones on my Melcom ST6000 alarm system?

After dismantling the PIR sensors for decorating, on re-assembly, although the red light comes on, the sensors... [Read more]

how do I reset my Billyoh PIR intruder alarm?

I have forgotton how to set the alarm I use on my shed. Please can you help?

Optima accenta g3 system locked, panel shut down?

I was removing a PIR sensor from the wall when decorating and set the tamper off a few times whilst removing/r... [Read more]

Please could I have the set up instructions?

My electrics were recently switched off and now my alarm is not working, please could you provide set up instr... [Read more]

Accenta G3 Sensors No Longer Working?

Hi, I have recently had to re-route a group of three alarms wires for my Accenta G3 system and the only way... [Read more]

Unable to set alarm Optima XL6?

My parents are unable to set alarm, none of the keys on control unit work? (although it's light up) the PIR's ... [Read more]

how to remove pir cover?

how do i set alarm so i can take a cover off a pir to check if any tiny spiders are inside setting off alarm.

setting fault?

i have just installed a accenta system i have a pir and a door contact in my exit route both are set as timed ... [Read more]

PIR light turns on and off too quickly despite timer set?

My PIR light was working fine but now when it detects motion it turns on and off very quickly. I have set the ... [Read more]

accenta G3 will not set?

Ater removing a PIR for house renovation work I have eventually relpaced it but now non of the other PIR's see... [Read more]

how do i get my Vitiras R8 into programming mode?

Hi can anybody assist we had a power failure and my system went into battery backup which totally drained the ... [Read more]

Home Alarm Systems?

i have scantronic 9448 for garage . fitted pir on enty & axit but alarm wont set do i need door magnet cencers... [Read more]

Why does my pir sensor not set the alarm off?

When I activate the alarm and I test each sensor one sensor doesn't work the pir sensor light is on but it doe... [Read more]

TAMPER LIGHT SHOWING ON RKP?

HI I HAVE JUST FITTED A NEW TEXECOM R8 PLUS WITH LCD RKP. BELL BOX IS A GARDTEC XS3D I HAVE WIRED FOR A GAR... [Read more]

Programming Optima Alarm 8 Zone?

I am having problems trying to set up a Part Set on Programme 2 I am told I need to change the Exit Mode from ... [Read more]

how do i program the enrty route into the panel?

when i set the alarm and walk infront of the pir it goes tofull alarm .....no entry tone, It`s value is set on... [Read more]

Alarm Will not set?

I have a veritas alarm system at the moment the unset light is constanly flashing on keypad and when code is e... [Read more]