PIR light turns on and off too quickly despite timer set?

I should also have added to my previous answer that you might want to adjust the lux setting a little as well.

Steve Mitcham
September 2013

The PIR has a lux setting which is sensitivity to night and day. When the light turns off then the PIR 'realises' it is night and immediately works i.e turns on, then because of it's own light source it 'thinks' it is daytime and wants to switch off. You need to shade the sensor from it's own connected light. These sensors also rapidly deteriorate and get brittle from direct sunlight. My solution for both these problems was to fix a hood over the sensor. I improvised with by fixing a small plant container for walls and fitted it upside down over the sensor.

Steve Mitcham
September 2013

i have a similar problem, when the light switches off it immediately switches back on.
I had it happen with a previous light so i changed it for a new one, it was ok for a few months but is now the same
Both were BQ cheapies

paul anzani
January 2010

Sorry, no answer but same problem, no idea why it does this (two lights do the same, the one near the front door and one near the back...).

So, if you have the answer, please!

Thanks!

Mark
December 2009

You could try to turn off the power set your timer and turn it back on again
Some pir's can only be set by turning power off then back on again.

Raffelect
November 2009