I have recently had to re-route a group of three alarms wires for my Accenta G3 system and the only way to do this was to cut each one and rejoin them using small junction boxes. Since doing that I am unable to set the alarm and the PIR detector no longer work. Also, the bell box no longer works. Any suggestions on how to get the system working again?
in the main panel check for fuses that have block you need 2 glass 1 amp fuses only if you have spair in the panel replace with them if you dont you need to visit your local alarm shop
Death . p.s the fuses blown should be either aux 13v/speaker or 12v and the belllbox bell/strobe
Death
January 2010
Automatic Answer
We may have found other answers which could help you.
howtomendit.com for free repair help, information and advice.
