How to mend ... Need Reset Alarm

my accenta 6 remote key pad is dead?

my accenta 6 remote key pad is dead, i came through the door, the alarm went off, i put in the code to stop it... [Read more]

I keep getting error "burg z07 alarm back door" when setting alarm?

How do I reset this to ensure this sensor on door works.

Security alarm?

Outside box still flashing following a reset,any ideas.

reset new code into dunnillscantronic9427?

i have moved into a bungalow with a scantroic alarm system. when I switch it on athe mains it will not stop bl... [Read more]

Scantronics 4700?

We came home to find our alarm activated,when we tried to reset it the fault light is lit and shows number eig... [Read more]

TS700 house alarm - BATT FLT and now no longer works?

Hi My house alarm is a networker TS700. It suddenly started going off this afternoon and displayed the "BAT... [Read more]

accenta 6?

hi iturned the power off to replace the lights in the hall and when i put th power back on the assensure 6 ala... [Read more]

Risco GT-480 Strobe stays on?

Hi I recently moved house, and there's ageneric alarm fitted. I've tracked it down as a Risco, the control pa... [Read more]

Scantron 9651 tamper alarm reset needed?

My darling daughter pulled the alarm off the wall whilst we were away.....it now says tamper reset and the spa... [Read more]

my keypad wont allow me to set alarm?

I have two Keypads and since a power cut my key pad by the front door wont allow me to reset or key code in to... [Read more]

accenta alarm will not reset after tamper code issue?

hi guys back again , bought a new battery as suggested an after fitting it my system sounded an alarm . entere... [Read more]

my optima pluss alarm system is bellping ?

my optima plus alarm system is bleeping and i carnt reset it and i dont have a manuel as its very old as in ol... [Read more]

Burglar alarm?

I have a siemans si 80-1 burglar alarm the orange light is on all the time , aany ideas how to reset it ??

Rearming Scantronic 9200 series after zone 1 alarm?

is engineering program code 40 the right code to reset rearm of zone 1 on Scantronic 9200 series alarm Set of... [Read more]

Dont know how to use Veritas R8Plus alarm?

I've just moved into a house with a Veritas R8 Plus alarm system. There are no codes for us to use to either s... [Read more]

Bgas swopped old meter for smart meter - Veritas Burglar alarm became disab?

I have had my Electric Meter of old replaced with a Smart meter by a British Gas Engineer.At some point in eit... [Read more]

Scantronic 9651 - Tamper Lid Reset required?

Hi I'm trying to fix my alarm after taking lid of control panel off (stupid mistake to make) and after gogglin... [Read more]

Where can I get a personal attack reset key from for CEF AP28?

The alarm box has been reset but the light is still flashing as I haven't got a key to rest the station.

how can i fix my renaut megane?

55 plate 1.9cdi when leaving the car double click on key card to lock lights flash as normal then after about ... [Read more]

How to switch off Tamper light permanently on in Accenta after fuse change?

The lights on the dial of an Accenta 8 Burglar Alarm system went off. Checked and replaced a blown fuse in the... [Read more]