How to mend ... Need New Control Board

Hotpoint wd440 refuses to go in to final spin?

I'm stumped by my hotpoint WD440 washer/dryer it will go through any cycle until it gets to the final spin, it... [Read more]

Diagnose Servis Rainwave bushless motor fault?

So, the tub on my machine is not turning. I've had the motor out and dismantled it. It is an electronically-... [Read more]

Hotpoint WM19P motor wont do anything?

I have just brought this machine (second hand) and thought i check it over took the lid off and done a quick w... [Read more]

Potterton Puma 80 firing on and off?

My Potterton Puma 80 comi boiler starts firing on and off after it has been running for a few minutes - both h... [Read more]

iHow can i fix my 10/16 boiler?

Please do you have a wiring plan for connections on to the Boiler control circuit board, as this as just been ... [Read more]

Hotpoint WM63 continuously fills and leaks through door?

My Hotpoint WM63 has recently starter "sticking" mid-cycle. The control know seems to get stuck. It then stop... [Read more]

Maytag MAH4000AWW repair?

Purchased in June 2000, motor control replaced in October 2000, due to machine shutting down when reaching spi... [Read more]

oster xb8216/b?

need control board xb8216/b

How do I fit WMA34 control board?

The door locked light keeps flashing on WMA34. I have replaced the door interlock but this did not clear the f... [Read more]

What is Search Glow?

I do ALT CTRL DEL.... in task manager I get Search Glow "not responding" ---------------------------... [Read more]

Can I replace the "antenna in jack" myself? I have the part?

I purchased a new "antenna in jack" for my Sylvania television, as I snapped the connector off. Can I replace... [Read more]

Kenwood A901 Speed control?

I took charge of a Kenwood Chef A901 but the previous owner had removed the small components from the speed co... [Read more]

Issue with Worcester 280?

Worcester 280...when the hot water is on it gets very hot then goes cold for a minute or so then comes on, get... [Read more]

Problem with Potterton 80e?

Potterton 80e DHW problem. When I turn on hot tap boiler does not start. If I turn tap off & back on about 1... [Read more]

Where can I get schematic for B&D B1561 breadmaker control board?

The knead panel on my B&D B1561 breadmaker wont come on. The motor cks ok. If I had a schematic for the contr... [Read more]

How can I fix Hotpoint WMS 38?

This machine starts the pre wash and wash but does go on to the rinse and spin. I can get it to do a fast spi... [Read more]

diagram for a hotpoint wms38?

can any one help i took my hotpoint washer apart to fix the rear drum and bearings and forgot how the wires ca... [Read more]

I am looking for a copy of the fault codes for a Fisher & Paykel GW601 Wash?

I have a GW601 washer that will go through the full cycle with no cloths in it but when loaded, won't take up ... [Read more]

Toaster Oster 6330?

the control board has a resistor burnt out. i need a parts list for it. can you help me. thank you.

My Kenmore ultra wash dishwasher control panel is dead?

We have been told the part is not available at the Sears parts store, that it has to come from the manufacture... [Read more]