How to mend Help Greatly Appreciated

2

Engine management light still on?

Please help my citreon xsara engine light Has come on I've check the usual faults but all seems Ok so how c... [Read more]

My Potterton Envoy keeps switching off. Can you help?

I hope some-one can help me; I have a Potterton Envoy 40 boiler which starts, gets established on the flame si... [Read more]

1

Vokera 24 losing pressure?

I have a vokera 24 combi that seems to be losing pressure. I pressurise the system to 1.1bar and while the he... [Read more]

Where does the red wire go!? Hoover HNV270?

Hi, I have been given a HNV270 dryer, the previous owner took it apart to change the belt, however they could ... [Read more]

2

Hoover vhc 180 doesn't run without switch held in?

The only way I can keep my Hoover vhc 180 tumble dryer running is to wedge a bit of card in the on/off switch.... [Read more]

1

replacing side to side brake pipe on vauxhall vectra?

hi, could someone please help, do i need to remove the fuel tank to replace the side to side brake pipe on my ... [Read more]

Key fob not working on astra bertone 2002, lights up but doesn't lock!?

When we purchased the car the fob had no battery holder. We have carefully replaced this and all looks well. T... [Read more]

3

Zanussi WJS1665W - does the Drain Pump need replacing?

Hello. We have had our Zanussi Washer / Dryer for over 10 years now. I clean the front filter on a regular... [Read more]

Halstead Ace High leak?? Please help!!!?

I seem to have a leak from my 'Hell'stead ace high, which causes it to lose pressure. I am no plumber so I wil... [Read more]

2

our laminate has lifted in a couple of places any advice?

we have laminate through our lounge diner, and in the entrance hall, where it goes from one room through to an... [Read more]

can anyone help?? I have a sportcraft tredmill that turns off after7 sec?

after 7 sec the machine turns off and a 3 shows up in the speed side.this makes no sense but if I turn the mac... [Read more]

1

How can I fix my Newhome 632?

Hi, I have a New Home 632 which has gradually become worse and worse for skipping stitches, breaking needles, ... [Read more]

3

how do i remove ford KA stereo?

HI, I don't have the pins required to remove my castette plater from my 52 plate Ford KA... any help will be g... [Read more]

1

retiming a shark euro pro 9110?

I have been told my machine needs to be retimed, how do I do this? Any help would be greatly appreciated. ... [Read more]

Ignis ADL347 is not washing the dishes properly?

The dishwasher is not washing the dishes properly. Dinner plates and cups etc come out looking partially wash... [Read more]

1

Repair Beko wm652s?

My washing machine has stopped mid cycle. There is all the relevant clicking as though the drum is about to st... [Read more]

4

my f&p gw612 - once wash completed goes to first spin, then alarms , lights?

hi there, My fisher & paykel (model GW612) gets past the wash cycle and when it goes to spin mode, alarms cont... [Read more]

how to fix my gateway mx3230 laptop?

My gateway mx3230 crashed! I use blackberry pearl as my modem, and since it crashed, I can connect online, but... [Read more]

1

GBC 4250 laminator doesn't heat up?

I'm repairing a GBC 4250 laminator for a customer. When you turn the mach. on, the OK light comes on at the s... [Read more]

Cuisine Art not switching off?

My Cuisine Art machine would not switch off automatically and water keep on pouring into the drip tray over fl... [Read more]