Probably a bad temp sensor. its located under the bottom heat roller center, held in place by 2 screws behind the lower spring loaded idler bar. the transistor fails open or the board comes unplugged and it can show ready when its stone cold. sensor part number is LM135h i think its available from digi key for about 12 bucks or you can order the board for about 200 bucks from GBC.
if you or anyone else have roll laminator troubles feel free to give me a call.
GBCs local first hour rate of $317.00 has been wonderful for my business
bob haller service and sales pittsburgh pa 412 366 4906
September 2011
howtomendit.com for free repair help, information and advice.
