How to mend ... Alarm Going Off Time

how can i fix my melcom st 6000?

i have just move in to a house the alarm that is in is a melcom st 6000. it has been without electric for some... [Read more]

one of my alarm sensors is constantly flashing?

I have a Eurosec PR5208 rev 1.0. I can't set the system without deleting that zone each time. the sensor is c... [Read more]

alarm would not stop?

Usually when the power goes off even for a short time the alarm ' bleeps ' for a few seconds when the power i... [Read more]

home alarm system ?

i have a c&k 236i2 alarm and the power led flashes on the key pad all the time what does this mean

ace house alarm problem?

both green and red light on at the same time , and if we try to put the code in it just makes a bleep sound , ... [Read more]

varitas r8? alarm misbehaves after a power black out?

I have a veritas installed and has always worked perfectly until we had a power failure. when power came back,... [Read more]

green flashing mains light,on my gardtec 350 alarm?

every time i input my code the alarm appears to set but on entry to the house,giving me so long to enter and p... [Read more]

how can i fix my alarm system?

After a fuse blew in the house the alarm a Paragon plus is now showing a red light next to fault, the last tim... [Read more]

scantronic 9800 fault?

Hi, I have a Scantronic 9800 on my house and recently it has started to go off in the middle of the day or ... [Read more]

Unable to partial set my C&K Securitech 800L?

We have recently experienced a couple of powercuts which activated the alarm. The alarm functioned correctly s... [Read more]

Control Panel flashing Rf problem?

My eight year old Scantronic 500r+ free wire alarm with four 515r PIRs have never given any problems until rec... [Read more]

My opmtima 2 plus alarm shows a zone every time I open the entry/exit?

This alrm has worked fine for ages now every time i open the entry/exit door the keypads display the number 1.... [Read more]

3 warning lights on pad. Not alowing us to reset?

The alarm has gone off while we were out. Normally it allows us to hit our code and then reset. This time al... [Read more]

how can I fix my veritas alarm?

My alarm has been working fine up until yesterday .I noticed the unset light flashing.When i pressed the full ... [Read more]

Turn Off?

How do i turn it off. We bought this house with this alarm we have no codes, and every time we have a power cu... [Read more]

how do I stop my internal alarm sounder going off when it's unset?

my indruder alarm internal sounder is going off a dozen times a day,each time I punch in the code and it happe... [Read more]

battery change?

hi all after changing the battry in a scantronic 9800. i have two key pads one ustairs and one downstairs t... [Read more]

How to change exit and entry times?

I have a Scantronic alarm panel 9452. I wish to extend the exit and entry times on the above panel. I have dow... [Read more]

how do i reset the strobe on my alarm?

I accidently set my alarm (accenta g3)off on sat, this was quickly stopped using the code. no probs, so i thou... [Read more]

how can I fix my paragon plus alarm system?

when alarm is set the exit tone still continues when normally it goes off after a certain length of time?