Mend > Chainsaws

how do i reasemble my pull rope and return spring?

i need help putting my pull rope assembly back back together on my homeline 27AV power stroke saw.

why does the oil run out of the electric chainsaw pks40?

The oil is not retained in the saw but runs out after finishing cutting - why is this?

Talon mixture screws?

I too would like to adjust the mixtures on my Talon blower AB 3201. I see the advice for adjusting, which I'm ... [Read more]

my ms180 chainsaw will not reach full revs ?

saw dies out when revs should reach full revs

sparkplug?

does anybody know the sparkplug gap of oregon pwr33cccsa chainsaw

will not prime?

oregon pwr33 chain saw I push the bulb in to prime .it is only half full and on the second push it stays in. t... [Read more]

homelite csp 3314?

i have no spark if the coil is out where to find in belgium

I have a stihl av 041 that I think has a problem with the clutch. ?

The chain doesn't release when in idle or when off. Is there anything that I can do to get the chain to relea... [Read more]

254 xp oil ratio?

what is the correct 2 stroke oil ratio for a husqvarna 254 xp ? many thanks

McCulluch mac 3200 chainsaw?

I need the fuel lines and manual

I have a stihl ms200t that revs up fine but want idle ?

I thought it might be the carb but I took it off and put it on another saw and it idled and ran perfect . I pu... [Read more]

cainsaw stops after 10 mins?

saw starts no problem but after 10mins or so sawing it cuts out ,once it has cooled down after 15 mins it will... [Read more]

no oil getting on chainsaw how do i repIr?

No oil getting on chainsaw blade how do I repair it JCB chainsaw

how can I fix my chainsaw?

the engine cuts out under full revs

need a part for a pro38cccsa?

hi how can i git a part for a pro patrol chainsaw code pro38cccsa if you take off the pull starter case off. ... [Read more]

Husqvarna 334 t will start won't rev up?

Will start and idle can go to quarter throttle when goes to full throttle starts to bog and sputter,

Where does the drive belt on a Husky rider 850-12 run?

Between the drive pulley and the deck pulley the drive belt goes either over or under the horizontal bar about... [Read more]

358350480 Craftsman 42cc 18in chainsaw. Not lubing chain?

Are there any ways to check if the chain oil pump is bad without replacing it? Could something be clogged? How... [Read more]

Makita Cordless Drill Charger wont charge batteries?

My Makita Cordless Drill Charger (Drill Model 6012D) is not charging the batteries anymore. Is the charger bad... [Read more]

Bad gas in 2 stroke engine? ?

I may have put bad gas in my blower, headger and weed eater. All used to run and one by one they quit running... [Read more]