Mend > Chainsaws

ms 180 shil chainsaw?

it wont start i have spark i put a small amount of gas in the cylinder put spark plug back in and it still won... [Read more]

How to replace perished fuel lines for Poulan Woodmater chainsaw 2250?

Fuel lines were perished. Removed them and attempted to get new ones. Was not able to find exact replacement l... [Read more]

how can i fix the petrol primeing bulb?

the primeing bulb has come out of the surrounding housing how do i put it back

how to fix Huskvarna 42 chainsaw?

The chainsaw starts, runs for about 1 second and then stops.

How can I rescue my Stihl 025 Chainsaw?

I had my chainsaw stolen but the police got it back. It seems that the burglars used it on pure petrol as oppo... [Read more]

stihlms170chainsaw?

bar clampbolts strippedfrommainhouseing bettertoreplacehouseingorepoxyinboltopening

Power Craft 650w Fuel Tap?

The Fuel tap on my Power Craft 650 watt generator has snapped off at the tank, how can I remove the piece that... [Read more]

how can i fix my chainsaw?

I got given a petrol chainsaw of my mate wasn't working. Followed the instructions on the case but still wont ... [Read more]

Husqvarna 350 saw?

My saw leaks bar oil when it is setting. What can i do to make it stop leaking

How do i remove my oil tank breather on my 266xp ? ?

My oil tank breather is plugged . I washed out the tank but its still plugged . What's the best way to remove ... [Read more]

how do i repair trigger on my husquvarna 235 chain saw?

how do i repair my trigger on my husquvarna 235 chain saw.I squeeze trigger and throttl does notadvance.

spares for an old husky chainsaw?

Where can I buy spare parts for a 1972 Husky 180S chainsaw?

chain sprocket parkside pks 2000/4?

i am looking for chain sprocket for parkside electric chainsaw pks 2000/4 serial no c141780 sprocket wheel is ... [Read more]

How can I fix my Husqvarna 254XP chain saw?

My Husqvarna 254XP has always been difficult to start despite an overhaul and its getting worse. Ignition seem... [Read more]

chainsaw eng prob?

eng will start but will not go to high speed

what could it be?

my ms 200t chainsaw idles fine but when i give it full throttle it bogs down and dies what could it be?

Sovereign SCS38 parts?

Where can I get a primer and handle spring for the above?

gcs-2000s oilfeed o ring which is oval?

where can i get an oval oil o ring for this model

how can re-assemble my ryobi 3335c chansaw?

how does the throttle re-assemble in the handle

If the oil pump drive gear spins on the crankshaft ... ?

After sripping my Mac Cat 839 and accessing the oil pump, the drive gear spins on the crankshaft, which is why... [Read more]