Mend > Stairlifts

terrys through floor wheelchair lift stop starts going up ?

terry's through floor wheelchair lift stop starts going up approx 9 times ever time its use sometimes less ,ha... [Read more]

lift keeps getting slower?

what IS MY lift doing is it the battery or what

420 now only moves up a few inches at a time?

420 now only seems to want to go up a few inches at a time... To re-engage it, I have to switch off the arm po... [Read more]

pcb board fuse ?

Stannah 420 stairlift. The fuse on the PCB board keeps blowing have put new batteries in had a spare PCB boa... [Read more]

Fault codes ?

Are there any e,plantations for the red and green led lights. When we engage the joyjoystick it just makes a c... [Read more]

Replace joystick on Stannah Stairlift?

The joystick on our Stannah stair lift requires replacing as it only intermittently works. The difficulty hav... [Read more]

Can I move the foot plate higher as I can't reach it?

Hi brought a 420 stannah stair seconed hand it all works but the foot plate is to low and I can't reach it ,so... [Read more]

paddle lever microswitch for minivator 2000?

hi - i have downloaded the parts catalogue for the minivator 2000 but cannot find the microswitch that sits be... [Read more]

how do I fix our Bison Beede stair lift, it goes up ok but will only inch d?

How do I fix our Bison Bede classic stair lift it goes up ok but will only inch down?

End Limits Activated?

After initial install, our unit traveled up and down full length three - four times. On the next trial run, th... [Read more]

code E ?

how do i reset code e on bison 50

Stannah 260 stopped on stairs - no power?

Our 14 month old Stannah 260 is used about twice a week. Today it stopped suddenly halfway down the stairs tw... [Read more]

bison 50 stair lift?

how do I reset code E on my bison 50 stair lift thanx

bison 50 stair lift?

how do I reset a E code on bison 50 thanx

Stannah 420?

Hi I've got a stannah 420 that intermittently slows down and eventually stops. I've changed the battries for n... [Read more]

My Minivator 1000 is stuck ?

My Minivator 1000 has gone unused since my father passed away. We have had it for three years. The lift got ... [Read more]

Replacing a stairlift motor ?

Hi, my grandparents have a stannah 420 stairlift that needs a new motor fitting. We have the part and my partn... [Read more]

(Code 11 ) Minivator 950?

code11 indicated how can I fix it I know it means over run can anybody tell me what I can do

my handicare simplicity 950 stairlift beeper indicates it is not charging?

how can I check to see that the batteries are getting the charge, the track has 33volts so it is somewhere in ... [Read more]

Stannah 260 not move LED1 is on?

My electric chair stannah 260 not move after a travel with telecontrol and indicates LED1. Could anyone helps... [Read more]