Mend > Home Alarm Systems

Guard tech panel fault?

Hi I have a guard tech 500 series alarm and on the panel it's shows the letter A which it says is a fuse fault... [Read more]

1

menvier 9651 wont set after wires cut?

My carpet fitter cut through the alarm wires, so I had to get someone out who solder it back together for me. ... [Read more]

3

Scantronic Ion-16, directional button on panel flashing red, why?

Any idea why the directional buttons on the control panel are flashing red? System won't arm since and cannot ... [Read more]

2

Moss ms2000?

My moss alarm keeps going off at the same time every morning it has not got a backup battery

Pyronix Paragon Plus replacement control panel?

The motherboard on my Paragon Plus control panel has given up the ghost. Can you please advise if I can still ... [Read more]

2

alarm panel reset?

I have had some work done recently on my electricity mains board, and now my veritas alarm control panel is fr... [Read more]

keypad won't program?

the keypad keeps returning to setup mode, I put in the date and time, but when I try to set the alarm it go to... [Read more]

1

Ameritech keypad replacement?

How do I get a keypad replacement for my Fixed Word Keypad model AM6128. The keys are so worn out they are not... [Read more]

1

Alarm goes off when electricity gives off?

When the electricity goes off in the village my 9200 alarm goes off when the electricity comes back on help.

2

Alarm goes off when electricity gives off?

When the electricity goes off in the village my 9200 alarm goes off when the electricity comes back on help.

1

Can I change user code on a veritas R8 alarm pad?

Is it possible to change the user code on my Veritas R8 keypad

3

sr fault code ?

Scantronic 9827 . Powered down and replaced battery , now have sr fault code . Will I need to reset NVM to def... [Read more]

1

How to remove TS500 alarm?

Hi, I have recently brought a house and the previous owners had a TS500 alarm installed. some of the wire... [Read more]

1

Veritas home alarm 8 ?

It is not setting

2

Scantronic 9448+?

Upon setting alarm and leaving house all sounds fine but when re entering it activates the alarm instead of gi... [Read more]

2

Problems after a power cut?

The keypad tones have changed The outside bell box blue light is flashing The outer hall sensor picks you up... [Read more]

aclenta G3 85p400 led pannl?

hi i have had a problem with my alarm so replaced the battery in the main board as thought this may be the pro... [Read more]

Optima xl4?

I have just replaced the battery. When I go to arm the alarm it doesn't, beep I have tried resetting but no... [Read more]

2

My altex alarm needs a battery?

Where do I install a battery in my altex alarm?

900c?

My 900c has the battery light on the key pad but tests at 12 volts