Bosch WTA2000-can anyone help me with correct element wiring positions?

Just to add further information to this:

>Terminal block goes:
>1 white/brown
brown live in on mains lead
>2 light blue and dark blue
blue neutral on mains lead
>3 not used
>4 black/white and Black (t/stat)
240 power return from on/off switch, timer and exhaust thermostat - if your exhaust thermostat is open there will be no power here

Element
>Far left pair terminals - black(t'stat) and black from loom
ring 1 power - if your rear heater (non-resetable) thermostat is open there will be no power here
>Right pair of terminals - red
ring 2 power - if your low heat is turned on there will be no power here
>Single terminal - blue from reset stat
neutral return via resetable thermostat - if your resetable thermostat is open there will be no link to neutral

also the thermostat wires can vary in colour due to source, in my case I have orange leads going to the rear heater (non-resetable) thermostat

Bill A
July 2007

Try This


Terminal block goes:
1 white/brown
2 light blue and dark blue
3 not used
4 black/white and Black (t/stat)

Element
Far left pair terminals - black(t'stat) and black from loom
Right pair of terminals - red
Single terminal - blue from reset stat

Paul
January 2007

Dan,
Have you found the answer yet. I also have the same dryer and have dismantled the unit and am about to re assemble. Just want to make sure which wire goes where!

Thanks
Bob

Bob Brown
October 2005

hi dan - may be able to help - i have this model and will go and take a look for you.

jason farmer
July 2005