My Hoover TC650 only runs if the 'ON' switch is held in, as soon as you release the switch it stops, If you hold the switch in it works normally, any clues thanks
two leads have come of the connection board not sure where they have come off...Can you help
clare flaherty
August 2016
I had the same problem myself , I changed the switch for a new one but that didn't do anything so I changed the start relay circuit board and it worked fine for a year but its gone again now.
Matt
August 2007
The problem is not the switches as previously mentioned, the fault is the start relay is faulty. It is a little circuit board mounted to the top front crossbar by two screws.
daz
July 2007
I HAVE THE SAME DRYER AND HAD THE SAME PROBLEM AS YOU I SPENT AGES WITH TAPE HOLDING TO BUTTON IN SO THAT I COULD DRY MY THINGS BUT IT IS NOT HARD TO REPLACE THE ON SWITCH YOU ONLY HAVE TO UNDO THE SCREWS ON THE LID THERE IS 3 THEN SLIDE THE WOODEN TOP OFF YOU WILL THEN SEE THE SWITCHES TO THE FRONT OF YOUR DRYER ALL YOU NEED TO DO THE IS UNDO THE SWITCH CONNECT IT UP THE SAME WAY YOU DISCONECTED AND THERE YOU HAVE IT YOU HAVE FITTED YOUR SELF A NEW SWITCH . JUST REMEMBER TO HAVE CONFIDANCE IN YOUR SELF ANY MAKE SURE YOU PUT THINGS BACK JUST HOW YOU UN DID THEM GOOD LUCK
howtomendit.com for free repair help, information and advice.
