Recent: Safely remove screen protector from a Macbook Air?

Mend > Washing Machines

Mend Hoover New Wave Plus 5 Wiring Problem Connected

wiring problem hoover new wave plus 5?

There is an orange wire bare end but not connected. Shoul this be connected to the red wire on the dryer fan motor?

CB
February 2010

Automatic Answer

While you wait for answers, we may have found some information which could help you.

Click here for Wiring Problem Connected

Related Questions ...

Mend thermostat heating installer
1

Danfoss REP230 Thermostat Wiring?

Long story short, I have the above thermostat and had an installer try to replace it with the new NEST thermos... [Read more]
Mend bought machine ago
1

Creda Model T620CW?

I bought the relay for this machine sometime ago, i then removed the old relay but cannot now remember the ord... [Read more]
Mend failed near side
1

failed parking lights near side only?

advice required my ford transit connect van has lost the parking lights on the near side, this has happened se... [Read more]
Mend year started trouble
1

Can I open the foot feed for my Paff Creative 1471?

About a year ago I started having trouble with my foot feed on my Paff 1471. My husband noticed that the littl... [Read more]
Mend wrong working house
5

What's wrong with my FX1465w?

Zanussi FX1465w door interlock is not working. I acquired this machine when I moved into my new house and it w... [Read more]
Mend car lights charge
4

Leasure battery?

Leasure battery 4yrs old and car & leasure battery charger which has panel lights indicating rate of charge. ... [Read more]
Mend How to mend it?
3

No spark from right side of contact points on 79 KZ650?

I had my 1979 Kawasaki KZ650C sitting out with the gas tank off while it was being painted and when I put it b... [Read more]
Mend light problem inside
1

3 gang light switch wiring?

I have a problem with a 3 gang switch - left controls an inside light, centre 2 spots and right 3 outside ligh... [Read more]
Mend zanussi checked brushes
1

zanussi washer/dryer?

ck thanks for your reply i have checked the brushes they r more than 10 mm no water or foam went in the pcb al... [Read more]
Mend valve heating drayton
2

problem with mid position valve? ?

I hope someone can clarify if I have diagnosed the fault that I think Ive got. A few days ago the central h... [Read more]
Mend problem light lights
1

lighting problem better explained?

new light fitting has 3 lights of which 1xblue & 1x brown wire come from each light 1 light unit in total i h... [Read more]
Mend alarm system fault
1

PROBLEM WITH 8EP396A OPTIMA COMPACT ALARM PANEL‏?

I'VE INSTALLED THE ABOVE ALARM SYSTEM AND HAVE A SLIGHT PROBLEM, THE SYSTEM WILL NOT ALLOW ME TO SET A PROGRAM... [Read more]
Mend need advice about light
2

I need advice about a light switch wiring?

I have just removed spotlights and a dimmer switch in a bedroom. then replaced with a standard switch and a fl... [Read more]
Mend wiring correct wires
4

Wiring Problem?

Last night I was wiring up a new socket in the kitchen, the wiring was correct because I had the new wires con... [Read more]
Mend problem replaced tube
3

Lighting Problem?

I replaced a 3ft fluorescent tube (ceiling) with a new 6ft one. The wires on the old 3ft were as follows: 3 ea... [Read more]

How to mend ...

Find out how to mend just about anything howtomendit.com for free repair help, information and advice.
Mend Washing Machines ...