How to mend ... Unit Alarm System

Moss Response MS2000 Alarm System?

Unit does not operate from any of the radio remote controls sensors. Would seem the radio receiver part in the... [Read more]

Bgas swopped old meter for smart meter - Veritas Burglar alarm became disab?

I have had my Electric Meter of old replaced with a Smart meter by a British Gas Engineer.At some point in eit... [Read more]

Scantronic 9751?

I have an intermittent fault on the 9751. The alarm will ring when the system is not active and there is no wa... [Read more]

Scantronic 9600 showing tamper unit tamper?

Hi Alarm been working for years (we didn't install it) now when we try and set it, after putting in the cod... [Read more]

rewiring a new bell box kinetic az-tech az 2000?

how can i connect my new external sound unit(az-tech ) AZ 2OOO.TO my gardtec 300series. what wires go where? t... [Read more]

how disable/ turn off cobra gold line alarm?

Alarm was installed post purchase of vehicle in 1992. The alarm had been disabled using the under bonnet key ... [Read more]

GSM autodial alarm?

I have recently fitted this alarm to my unit/lockup.The alarm goes off several times a night for no reason.Thi... [Read more]

Moss MS2000 erratic alarm?

Answers - mend, repair, fix Hi Noticed this old thread I am having a similar problem to the one in an old... [Read more]

central locking system?

i have a 2004 mazda 2.5 turbo diesel-central locking system and alarm does'nt work from transmitter - battery ... [Read more]

What do I need to do next?

I have a Scantronic 500r+ alarm fitted, The unit has been lying dormant for some time now (although prior to t... [Read more]

Replacing the cable between the control unit and door sensor?

Hi, our alarm keeps going off as the system believes it is being tampered with whareas all that has happened i... [Read more]

Update - XM6 Alarm Panel Not Responding?

Hi again.... further to my previous post... Having dismantled the panel, I have found a burned out resistor o... [Read more]

i have an sl8 intruder alarm system?

I have moved into a new unit with this alarm system fitted but dont have the code is there any way i can reset... [Read more]

Ranger American PC1550?

QUESTION: Good Morning I have a Ranger American PC 1550 unit in my home I just replaced the back up battery a... [Read more]

Veritas R8 remote not functioning properly after power outage?

Lost mains power and internal alarm sounded my daughter attempted to reset bu alarm just timed out after 20min... [Read more]

Alert message on 9651 Scantronic Unit states Kitchen Z04 ? ?

The scantronic alarm system keeps going off .. each time it reads a message stating Kitchen Z04 - does this me... [Read more]

guardtec 300/500 series?

just got a cat and want to zone out a section to prevent the cat setting off the alarm. Used the removing zon... [Read more]

Golf Mk3 immobiliser stops engine, will not start?

Golf Mk3 1996 TDi. The engine cut out a few times when driving and occasionally would start back up if I was l... [Read more]

Sensor Replacement or Removal in a Safewatch Plus RF?

I have an ADT "Safewatch Plus RF" alarm system and one of my "Sensor 9" module has gone wonky. Is there any p... [Read more]

home alarm system?

I bought this house vacant pocession with a chubb 6000 unit installed the alarm went off. I disconnected the b... [Read more]