Recent: Fix food processor motor?

Free repair help and information

howtomendit.com find out how to mend just about anything.
Categories

Mend Starts Throttle Cleaned

Free repair help

We have 45 questions about mending 'starts throttle cleaned'

How to mend ... Starts Throttle Cleaned

Pages 321
Mend strimmer fuel mix

petrol strimmer cuts out?

challenge extreme strimmer starts but cuts out oncethrottle is applied fuel mix correct air filter cleaned,sta... [Read more]
Mend driving starts fine

Zafira 1.6 2002 losing power?

Please help...my zafira is losing power when driving. It starts ok and ticks over fine. I have changed the EGR... [Read more]
Mend Vehicles, Cars

Astra 1.8 keeps cutting out - any ideas?

My 2008 astra 1.8 auto with 25 k miles keeps cutting out, surges, feels lumpy but starts first time afterwards... [Read more]
Mend starts throttle cuts

zzr100 wont rev?

zzr1100d2 starts but idles lumpy,when throttle is turned it cuts out.used to run perfectly even when not start... [Read more]
Mend renault megane sport

Renault Megane Sport 225 dilemma?

Hi, I have a 2004 Renault Sport Megane 225 Phase II. No mods, K&N short ram replacing the standard air box set... [Read more]
Mend changed control sensor

clio 1.2 y reg?

changed temp control sensor near the throttle body cleaned throtle body also put new plugs and coil stil stall... [Read more]
Mend stop engine throt

How do I stop my Kohler Command Engine from governor hunting at full throt?

I have aCV25 Spec.#69534 Kohler Command Engine I recently overhauled for a friend the engine starts instantly ... [Read more]
Mend speed engine starts

Hayter 10/30 wont run fast/operating speed?

Engine starts but will only idle. When throttle opened engine gets noisy, as if no silencer fitted, but doesn'... [Read more]
Mend craftsman hp model

Craftsman 6.5 HP model 917.377543?

Ok I had this uh problem that was immediately followed by another. It starts up fine, usually 1st pull but the... [Read more]
Mend engine throttle fine

Engine bogs down?

2007 TGB 50cc scooter bogs down the more throttle I give it. I let off throttle an runs fine, can't get it ove... [Read more]
Mend Vehicles, Motorcycles

Idling problem????

I have a 2000 X reg Gilera Coguar (it has a copy of the Honda 4 stroke single cylinder engine (old cb125 singl... [Read more]
Mend carburator start runs

carburator adjustment?

i have a ryobi ss30 start plus model ry30040a. it starts and runs. it boggs down from 1/2 to full throttle. i ... [Read more]
Mend 100cc fine throttle

I have a peugeot elyseo 100cc 2 stroke, starts/idles fine but revs don't in?

when i twist the throttle revs don't increase but volume increases and it makes a bassy hollow noise. the rear... [Read more]
Mend Vehicles, Motorcycles

Sukida 50cc splutters at full throttle when warm?

Hi, I have a sukida sk50qt Roma, it starts first time everytime, ticks over smoothly but after a couple of min... [Read more]
Mend starts throttle cleaned

Starts but will not take throttle?

Replaced diaphram and cleaned crb thourghtly
Mend bike running starts

piaggio zip?

hi im having trouble with this bike it isnt running well it starts fine and gos ok it just feels like its cold... [Read more]
Mend mini moto cuts

my mini moto quad starts but?

my mini moto quad starts but when i release the throttle it cuts out, iv cleaned the carb .e.t.c, but dont see... [Read more]
Mend vauxhall dti starts

vauxhall vectra 2.0 dti 2002?

engine starts and idles when applying throttle no revs then a delay then revs burst into life when trying to d... [Read more]
Mend bilt trimmer starts

Troy Bilt TB20 CS trimmer stops?

My Troy Bilt TB20CS trimmer will run about 10 minutes or until it starts getting hot, then will not accelerate... [Read more]
Mend engine speedfight 50cc

excessive high revs when engine starts?

Hi I have just rebuilt a speedfight 50cc moped, new crankshaft bearings seals etc new barrel and piston, when ... [Read more]
Pages 321

Ask Question

Ask your question Do you need free help? Ask your question.

howtomendit.com for free repair help, information and advice.
Ask Question