How to mend ... Replaced Gasket Going

smoking focus?

just had timing belt replaced on 1999 1.6 zetec,bent two inlet valves due to bad info,replaced all eight inlet... [Read more]

Ford Galaxy overheating?

I have a 2006 Ford Galaxy & I have a problem with it overheating, at first my Ford dealer just flushed the sys... [Read more]

Paiggio NRG starting issues - continued !!?

Right..to add to my last post ref starting issues..my struggle continues....(bike decelarated whet to acellera... [Read more]

rover 25- misfire on tickover, poor starting, fuel pressure?

hi i have a rover 25 1.4, it has a problem starting, accelerator needed, and on tick over it misfire's-however... [Read more]

Blown head gasket?

I have a SEARS Craftman 6.25 Mower with a Briggs & Stratton engine. It is very difficult to start ( usually ab... [Read more]

timing chain?

replaced head gasket on a corsa 4 pot chain engine. car wont start fuel an spark ok lad did not use the timing... [Read more]

my 1995 ford escort wont run just replaced the head gasket how can i fix it?

i just replaced the head gasket on my 1995 ford escort, all fluids, spark plug wires. there is one electrical ... [Read more]

Kenmore 564.2950 small upright freezer?

I have the noted freezer cleaned out & defrosted. Replaced the door gasket as the old one was ripped. Plug it ... [Read more]

2006 Focus 1.8 TDCi losing water/coolant???

My Focus is losing alot of water/coolant (about 3 litres over 40 miles) once the engine warms up? No signs as ... [Read more]

water hose?

have just replaced the water hose on my radiator and top up the coolant but it started steamin again and i thi... [Read more]

rover 25 05 heater blowing cold?

rover 25 05 20.000 miles heater blowing cold,heater tap ok heater matrix not blocked had head gasket water pum... [Read more]

Condensation on Nearside headlamp of Citreon C3?

I have just replaced the Main beam bulb and the indicator bulb on my son's Cireon C3. Hoever since replacement... [Read more]

coolant is bubbling. knocking sound from engine?

Both these problems began after the the thermostat on my renault megane '04 burst a seal and the engine overhe... [Read more]

How can I fix my Briggs & Stratton rototiller carbuerator?

I have a Craftsman rototiller with a B&S enigine #137202 that is not drawing fuel from the tank to the carb. I... [Read more]

rover25 impression 1.4?

Hi. Ihave just bought a Rover 25 2002plate. There is a knocking noise from the drivers side of the engine when... [Read more]

how do i set the timing on a ford mondeo 1.8 2002?

I have replaced the head gasket and am having trouble resetting the timing

my lawn mower leaks gas from carb?

i replaced the head gasket started up on the first pull but had a gas leak from the carb, i rebuilt the carb b... [Read more]

Punto overheating?

Hi The temperature gauge on my punto went into the red today and there is no heat coming through the vents i... [Read more]

Ihave just replaced the head gasket on my fiat punto TD 60 however?

I have just replaced the head gasket on my fiat punto TD 60 however when i go to start it up, the engine turns... [Read more]

wot causes engine 2 pressurise immediately?

just fitted cylinder head to a renault kangoo 51 plate diesel van and the engine pressurised immediately.it ha... [Read more]