How to mend ... Problem Hello Board

Jaguar boiler F1 code?

Hi the have bin installing a new pcb board and a gas valve still the F1 code keeps on the display and the boil... [Read more]

Renault megane 53 plate, card not detected and won't start?

Hi, I have recently bought a second hand renault megan on a 53 plate. There were a few faults already on the c... [Read more]

Regarding red ring model 5005 expression ?

Have a problem with the shower heating the water after it's been switched on , I'm getting a little heat with ... [Read more]

How can I fix my fire place?

Amish Mantle Fireplace. It works well but the flames do not come on Have replaced the bulbs and that is not ... [Read more]

gss22jeta ww freezer problem?

Repaired defrost heater, replaced thermistor in freezer, and ice cream in freezer not hard. Freezer temp at 20... [Read more]

aclenta G3 85p400 led pannl?

hi i have had a problem with my alarm so replaced the battery in the main board as thought this may be the pro... [Read more]

Panasonic TXL37G10B power supply problem?

Hi, I have a panasonic tv and would like to check the voltages from the power supply. I have looked at the sc... [Read more]

Does changing 1uf capacitor fix abnormal defrost light behaviour?

I have had my Delonghi DEM10 for around 5 years. It has worked flawlessly until now. The Defrost light flashes... [Read more]

is the problem the control board or the gas valve?

I have a Vulcan Powerhouse 100 gas heater, it won't start, on reset, green Led blinks 6 times, fault table say... [Read more]

Dcmd67 resistor problem?

Hello, I have a treadmill DCMD67 board that is broken. Has burned k15n60 and resistors R63 and R65. The probl... [Read more]

how can i fix my renault megane 2009 aerial circuit board?

The aerial circuit board must have developed a fault as stations have very bad reception. Have changed the ae... [Read more]

Russell Hobbs Steamglide iron ?

I have my iron about 14 months and its playing up ,every time you press button for steam it trips the circuit ... [Read more]

Are there any remova instructions?

I have an internal erro on my Almera Tino display in the dash board, Nissan want to charge me £87 per hour to... [Read more]

Dish drawerDD60D (apparently DD606) touch control board?

Have another problem, when I changed controllers between drawers, the cycle touch control panel issue moved wi... [Read more]

How to remove radio /cd from fascia panel?

Hi on Honda Jazz 2002 Cd: How do you remove the radio/Cd unit from the back of the fascia. I have the fascia ... [Read more]

Delonghi DEM10 EX2 not collecting water?

I have changed the relay 835L-1A-C, however problem not solved. Others are writing about changing the capacito... [Read more]

Where can I get a circuit board for a P Pro drill?

..... My Performance Power Pro Dremel-type drill has failed. The fuse and cable are O.K. The motor windings t... [Read more]

Kenwood A901P changing speed controller?

Hi Because a capacitor had burnt out on this mixer I purchased a replacement speed controller board from espa... [Read more]

OM 99732?

I have the same problem as others. In Auto it will not run. Works fine in reverse. I see where someone jumped ... [Read more]

Cannot set alarm?

DB board tripped after this our omnicrom 9000 alarm won't arm. Punch the code in no problem Peres arm there is... [Read more]