How to mend ... System Gone Out

I need instruction manual for DTI DSS-52?

My door bell is hooked up to this system and I know the house was built in 1980 when this system was installed... [Read more]

I need instruction manual for DTI DSS-52?

My door bell is hooked up to this system and I know the house was built in 1980 when this system was installed... [Read more]

Gardtec 300/500 series- key pad shows 1u. ?

Your Gardtec 300/500 internal alarm is going off while the keypad is show 1u. The code doesn't shut off the a... [Read more]

Honeywell Accenta Gen 4 - LCD Keypad - Power Light but not responding?

We have an alarm system set up with a single Honeywell Accenta Gen 4 LCD keypad. This has been working well... [Read more]

Can I use a Scantronic 9448+ panel without door contacts ?

I have replaced my old security system panel with a new Scantronic 9448+ model.. Originally did not have Door ... [Read more]

Blank remote keypad?

My remote key pad is dead, days ago I had to remove keypad from wall to decorate, when closing keypad t hangi... [Read more]

Bentley house alarm rings on entry?

Our house has a Bentley f133 alarm system, I must have mis-keyed some buttons as when we enter through the mai... [Read more]

how can i fix my 9448?

battery was flat following a power cut, new battery fitted. how do I restart system

Scantronic Ion-16, directional button on panel flashing red, why?

Any idea why the directional buttons on the control panel are flashing red? System won't arm since and cannot ... [Read more]

linking sensors?

I needed to move my sensor in 2 different rooms which were connected via a loop system. I cannot remember whi... [Read more]

Scantronic 9200 alarm?

I have the scantronic 9200 alarm in my house, worked perfectly fine until today - usually it has a light on th... [Read more]

Nexus 8 alarm system - constant bell tamper fault?

My neighbour's home was burgled and the Nexus 8 alarm, which I fitted years ago, activated. Burglars smashed t... [Read more]

veritas 5va alarm system?

hi we've got a veritas house alarm system on the box it says 5va yesterday the box in the house started to sou... [Read more]

Can i remove a PIR from the Alarm system by just disconnecting it? ?

I have had a new french door fitted and the old PIR is no longer needed. I was going to disconnect and put the... [Read more]

How can i get rid of BELL TAMPER message on home alarm?

Hi guys, this is my first time on a forum like this. Our home alarm is showing a BELL TAMPER message so I can... [Read more]

why no led lights flashing on my magnetic sensors using with g3 alarm syste?

my led's on my magnetic door and window sensors no longer flashing , this happened after putting new back-up b... [Read more]

Missing battery/system reset?

My 9930 alarm keeps going off internally - keep putting my pin in but it's only lasting few minutes then goes ... [Read more]

how to fix scantronic 9751 K01 Tamper reset?

hi guys, cant seem to reset my Scantronic 9751 system it keeps showing K01 Tamper reset no matter how many tim... [Read more]

9600 Scantronic?

Microprocessor intruder alarm system Unit tamper -- reset no. required

How do I reset optima xm alarm, showing. Attack?

I have just cut the key button wire by mistake, how do I re connect and reset system?