How to mend ... 8 Its Not Even Set

showing zone 6 and 7 open and wont arm?

i have got scantronic 9651 ewith 9943 keypad. it was working fine till there was a power cut for 12 hours. whe... [Read more]

Tamper Light?

Hi the power went off and when restored I the tamper light has stayed on I cannot set the alarm, I have tried ... [Read more]

delay entry time?

my veritas 8 just goes off as soon as i open the door. how do i set a delay time

C you can turn off the solid tone on a Scantronic alarm 9427?

After doing a partial set of our alarm in the house (we have a dog in one room) We have 10 secs of a solid key... [Read more]

eurosec cp8l?

I have a Eurosec CPL8. An engineer fitted this for me and yearly he contacted me and said my alarm needed serv... [Read more]

Unable to set Optima alarm?

I am unable to set my alarm. The control panel lights look normal but when I enter my code, the beeps are norm... [Read more]

Chime when open front door ?

Door chimes on opening even when alarm not set. Have tried re setting and pressing 0 but still continues

scantronic 9449/9427 alarm activating when setting alarm?

Recently replaced the backup battery and now when I set the alarm the alarm activates and when I enter the cod... [Read more]

alarm not resetting after entering when i have omited a zone?

when I have set the alarm having omitted a zone, when I come back I I enter my code and press reset but the al... [Read more]

Veritas r8 ?

On the control pad no 6 when pressed sticking not bleeping when press, unable to set alarm. How can I change m... [Read more]

I have code E showing on my Scantronic 9827 pad Can't activate alarm?

Scantronic 9827. Having changed the battery I tried to activate the alarm but pad display shows E. I have att... [Read more]

scantronic 9200 - show area two issue?

HI, i am staying in someones house and they have given me the code to set the alarm - however when i have trie... [Read more]

Scantronic 9651 aux dc fail?

I have just amended the programmed zones so that the kitchen sensor is not set when setting the system using B... [Read more]

Unable to set "Night Set"on CEF AP28?

Following series of power failures I am now unable to set a "Night Set"on my alarm CF AP28 Key pad.Used to set... [Read more]

Honeywell Accenta Gen 4 - LCD Keypad - Power Light but not responding?

We have an alarm system set up with a single Honeywell Accenta Gen 4 LCD keypad. This has been working well... [Read more]

Fault code on alarm panel?

I have a Risco G Tag wireless alarm and I am receiving the following message. Back door show b. The alar... [Read more]

Alarm sounds inside but not outside?

In full set or part set the alarm bell / sounder does not work, on a bell test the bell does not work either

open zone?

I had to replace the control board, but when I try to set the alarm it comes up Open Zone 7 Z07, I've tried r... [Read more]

alarm beeping unset and power button flashing?

just after bit of advice please got up this morning and alarm was making a beep noise around every 30 seconds ... [Read more]

how to reset Lcd panel after power outage accenta G4 mini?

When power was restored after an outage the LCD unit was displaying a line of black squares along the top of t... [Read more]