Mend > Tractors

Why does my four wheel drive on my ford 7840 sle slip under light load ?

Why does my four wheel drive allow the front wheels stop spinning when I am driving my ford 7840 sle powerstar... [Read more]

karcher 620m?

the motor continues to run after the flow of water is stopped.

1

jcb 3cx gear switch ?

thanks don i will try that at the weekend are these repairable ? or do they just where out ?

3

jcb 3 cx 86 E will not start its not the ignition swich?

no live to starter when in start position shuttle gear change think its a safety switch but where is it ? will... [Read more]

2

jcb 3c mark 3 1978 498nt leyland engine?

Engine runs well and would tick over for ever but under load it lasts about 5 minutes and then dies and will n... [Read more]

how to adjust the handbrake on citroen c8?

trying to adjust my handbrake but can't see how

1

how do i fix a drain in the electrical system of john deere 950?

the tractor will start with a brand new battery but kills the battery with 60 days and it will not start again... [Read more]

2

How can I fix the boot catch on my peugeot 406?

The boot catch on my Peugeot 406 will not catch! The mecahanism looks as if it off centre and has been knocked... [Read more]

1

JCB 3cx pwershift 2001?

hi ... i have a problem in my jcb 3cx powershift 2001.the problem, when i change from nutural to 1 0r 2........ [Read more]

1

What is wrong, NH 7840 transmission not pulling?

I have a NH 7840 SLE that was working fine yesterday. Today, we backed it out from under the barn, turned and ... [Read more]

1

Merlo pick up hitch smashed!?

Hi THe hitch was down as I reversed over a kerb. Bending it. Now wont go up or down. IS it ok to disc it off o... [Read more]

5

My 1980 JCB 3cx is loosing transmission fluid & drive. ?

I fill up the transmission fluid but then after a couple of hours it starts to loose drive (forward first). Wh... [Read more]

2

jcb 3cx white cab model,Lost drive in forward but reverse is normal?

Checked transmission pressure at 1000rpm approx 10 bar,12 at 2000rpm.Maybe forward clutch pack faulty.how can ... [Read more]

1

I have an error code E34 flashing on a ford 7840. what is it?

Error code e34 flashes on dash of ford 7840 L reg and also has no biting point on cluch? Can anyone help?

2

error code 06 plate tm 120?

only sometimes i get code te4 pto on the dash board anyone got any idear

forward gears are fine go in reverse and it moves very slow?

have a 3520 tractor, forward gears are fine go in reverse and it moves very slow?

1

how to fix error code e48 on 93' 7740 ford tractor?

my '93 7740 ford tractor flashes the code everytime i start it. It will sit and run, but when i try to move i... [Read more]

jcb 3cx 2002 electric problem?

i have a jcb 3cx 2002 that temp rarning light slitley cums on wen i shake my front bucket witch puts my warni... [Read more]

l4310kubotatractor?

howtoremovefrontaxleshafttoreplaceoilsealon4wdtractor

1

murry lawn tractor?

starts up but when releasing the clutch and its in gear the tractor wont move and dies out.could it be one of ... [Read more]