I keep getting error code E41 on my NH 7840 and lose transmission. If I stop and resart the tractor it corrects it but soon happens again. Can anyone tell me what this code means?
Guyz i need your help here... My ford 8340 its showing e41 and smtimes it cnt even move.... What could be the problem
kenny
June 2014
I have a 7840 and these are the codes that come on my dash (CP, C11, C37 and C47) would ny1 help me
Jack
April 2013
12 X 12 C1 (Low) clutch solenoid open circuit
giorgos
January 2013
hi there, just wondering if you found the fault from error code E41? i have the same fault on a newholland 8340 sle
geraint jones
November 2011
hi my 7840 pto wont work under load
aidan
December 2010
The four clutch solenoids (p.w.m valves)are mounted externally on the right-hand side of the transmission case behind the battery and transmission accumulator. C1 towards the front axle fowlled by C2,C3 & C4. they are mounted vertically in a line. The solenoid coils are retained by a nut on the p.w.m. valve stalk this nut is lightly tighten just to "nip" the soleniod coil into postion, do not overtighten.
Ash
November 2009
Thanks Ash
The tractor is a 7840 SLE with powershift gearbox.
Not sure how to swop the position of the solonoids though.
Markned
November 2009
Presuming 16x16 Quad mod transmission. E41 is due to the C3 clutch solenoid open circuit. Suggest you swap postion of solnoid to C2 postion and see if the fault moves, if solonoid faulty E43 will be displayed. Could also be wiring fault in harness.
Ash
November 2009
Automatic Answer
While you wait for answers, we may have found some information which could help you.
howtomendit.com for free repair help, information and advice.
Try fixfault.com to fix tractors.