Mend > Lawn Mowers

1

my pull cord snapped??

my pull cord snapped so i bought a new cord then pulled the cover off to put the cord back in but i cant see w... [Read more]

1

how can i fix the carberator rods?

i have a sears rear motor 8hp 30in cut the carb was replaced but the rods were left hanging is there a diagram... [Read more]

2

How can I fix my 6.5 briggs and straton?

What can be wrong when all the gas will run out the little hole in the primer? I have replaced the air filter... [Read more]

1

How do I change oil in 6.75 22inch Craftsman self propelled?

How do I change the oil in my 6.75HP 22 inch self propelled Craftsman mower, I can't find a drain plug and hav... [Read more]

1

Magneto Setting?

Magneto Gap Setting for McCulloch Eager Beaver 282.

1

how do I replace a drive belt on a white tractor?

I am trying to replace the drive belt on my White tractor. I can't seem to tighten the belt. Is there an idler... [Read more]

1

Leaf Blower runs on choke?

Hi, Hope you can help with my older Briggs, Little Wonder leaf blower. Model # 9005PD Engine #130202 1670... [Read more]

2

how do i fix broke lawn mower pull cord?

i have a broken pull cord on our lawn mower,so we cant start it. It is a Vantage 3.5 We tryed to rewind the c... [Read more]

2

BELT INSTALLATION ON A CRAFTSMAN 16HP RIDE ON?

I WOULD LIKE TO HAVE A DIAGRAM SHOWING ME HOW TO INSTALL THE BELT ON MY CRAFTSMAN 16HP LAWN MOWER. MODEL # 91... [Read more]

1

What makes pull cord so hard to pull?

The pull cord on my lawnmower is near impossible to pull. My son can get it started, but it is just too hard f... [Read more]

4

Craftsman 9hp shredder B & S engine starting problem?

My chipper is having a bad day..... When you try to start it, it will turn over, but then it runs really slow... [Read more]

1

B + STRATTON 375 motor "hunts"?

Lawnmower starts fine then after a few second (maybe 10) motor speed surges up and slows right down.Goes up an... [Read more]

2

how do I get my craftman lawn mower to start?

How do I get my craftman lawn mower to start? I changed the sparkplug, but still does not have spark. It see... [Read more]

1

my riding lawnmower takes off hard and fast?

When we start the riding lawn mower it seems to take off to the point that I hang on, then it goes fine. How ... [Read more]

2

how do i put the deck belt on a model#917 craftsman riding mower?

i have a model#917 craftsman riding mower and i have no idea on how to put the new deck belt on. this is the b... [Read more]

1

Carberator conections for Tecumseh engines?

I need a diagram of ALL cable ( throttle, choke and govenor) conections to the carb on the Tecumseh BVS143 eng... [Read more]

5

12hp Briggs engine?

Something loose in the engine. I have it off the rider, when turning it by hand ,sometimes something catchs i... [Read more]

3

I have a craftman eager 1 model # 917388360 push lawnmower?

when it start after just a few minutes it shuts off . I replace filter,plug.It ran that day with no problems a... [Read more]

1

When I release the handle on my?

6.25 HP Craftsman lawnmower, the mower does not shut right down. It coughs and burps and tries to continue to ... [Read more]

2

Hard starting Snapper rider?

I have a rear engine Snapper rider with a manual recoil starter..called pull and pull and pull somemore. If I ... [Read more]