Mend > Home Alarm Systems

Optima XM system keypad not working?

I have an optima xm alarm system and the power & day lights are on but the keypad buttons are not working. No ... [Read more]

i have just moved to a new home which has an optima xm alarm and i don't kn?

optima xm6 alarm does not arm no instructions

gardtec 500 panel what would be the connections for a new bell box inside ?

gardtec 500 panel. what would be the connection for a new bell box. 500 connections are atch, power + -, str... [Read more]

how can reprogramme my alarm system?

my battery on the alarm is dead so i changed the battery but now my control panel is not working

I can not set my alarm?

I have a Guardtec 500 alarm, I switched the mains power off to do some electrical work and I am now unable to ... [Read more]

veritas 8C security alarm?

alarm would not switch off cut wire how to repair the alarm also need manuel

Accenta 8-system is busy?

I returned from holiday and cancelled the alarm. When later the same day I was going out again, I pressed the... [Read more]

How to dismantle burglar alarm as making a terrible noise?

Hi there, i have a burglar alarm that is screeching like made and it doesn't stop after 20 mins like some, it ... [Read more]

how do you reset aused alarm key pad ?

how do you reset a old alarm key pad for a different location.

tamper flashing ?

tamper light flashing all the time on accenta 8 mini

Accenta 6?

We have accenta 6 alarm fitted however the buttons are now stuck. We have lost the manual and would like to ch... [Read more]

changing the code in a optima xm?

how can i change my alarm code in a optima xm

gardtec 300 series?

We have a gardtec 300 series. The outside alarm goes off for 20 minutes for no apparant reason- as its not set... [Read more]

model 9600 ?

how do i change back up battery on 9600 when i opened front cover alarm whent of.

accenta 6 alarm codes?

we just moved house previous owner didnt have an alarm code just pulled the fuse how do i re set without code ... [Read more]

GARDTEC 300/500 ALARM?

Gardtec 300/500 = 360/580 Alarm Showing Ct on the panel. If I take the fuse out and set the alarm going then ... [Read more]

accenta alarm rkp shows ta tamper and wont respond to any input?

We have tried to reset the panel and to clear the NVM but then the power light goes out on the rkp and once we... [Read more]

re engineer mode?

how do i get engineer mode off my cp171 the alarm system is a galaxy 8

Gardtec 300 - maintenace mode?

I need to turn the mains off for 30 mins or so but the alarm will of course go off for about 20 mins. Is there... [Read more]

melcon st 6000?

what is the enginering code for the melcon st 6000