Mend > Home Alarm Systems

1

scantronic 9452?

zone 4. led stays on when alarm set for exit. able to switch of when entering entry code. told it was a reed s... [Read more]

1

back up battery for melcom st6000 alarm?

we need to replace back up battery. need number and if replaced will it lose the programme and settings

how to stop alarm sound from scantronic 9800?

bf showed up on key pad ,alarm sounding high pitched noise from battery box which is located in the garage,fit... [Read more]

resetting nvm on a accentra 6?

hi can anyone tell me how to reset the nvm on a accentra 6 system. i had a power cut resulting in a loss of po... [Read more]

can i re-set the accenta6 alarm?

we moved into a new property nov 09, switched on the alarm the alarm sounded.Contacted previous owner for p... [Read more]

How can I fix Sterling 10 RINS415-2?

Alarm is going off and there is a bell icon.

4

How do I change my front door to be the same delayed exit time as back door?

How can I change my front door to have the same exit delay as my back door on my alarm system Gardec 360/580

4

can i disable pa ?

can i disable pa, the alarm goes off randomly when unset, and i don't want to pay a zillion quid just to get s... [Read more]

2

How Do I reset the alarm without any codes?

Hi, Me and my partner do not have any of the codes as the alarm came with the house and we cannot contact t... [Read more]

3

What PIR is required for a Scantronic 9452 Intruder Alarm?

What PIR (modle number) is compatable to a Scantronic 9452 Intruder Alarm.

3

exit beep?

why is it that when we enter our security code the exit beep doesn't stop

Your Question HAS been Asked Before?

Top right, there is a search facility

3

is there anyway to reset an Optima XM Home Alarm?

I've just moved into a flat with an Optima xm alarm but have not got the code for it is there anyway to reset ... [Read more]

How do I get my Ranger American PC1550 from "armed" to "ready"? ?

We have a Ranger American PC 1550 system installed in 1993. We moved in Dec 2006. No manual or security code... [Read more]

1

how can i change my pin code on my melcom st6000 home alarm?

hi just wondered if any one knows how i can change my security code on my melcome st6000 home alarm i have the... [Read more]

1

House alam won't stop! Advice please?

We have just moved into a house with a 'Veritas' R8Plus house alarm; in the middle of the night it went off, w... [Read more]

I cannot reset my Home Alarm - Veritas 8?

Last night my Alarm sounded when my light switch tripped in my living room. Both the internal (control panel)... [Read more]

1

all zone lights are red when trying to arm? ?

My alarm will not arm. The zone lights are all red as if a fault but with every zone??

1

How can I fix my Eurosec CP8L LCD ?

After setting the alarm it is sounding on returning home. The display always shows that it is the same sensor... [Read more]

1

no slow entry tone?

My alarm sets ok but as soon as i get down stairs in the morning there is no slow entry tone the alarm goes of... [Read more]