Recent: Will I need to replace my garden tap?

Mend > General D.I.Y

Mend Optima Compact Sensor Fault Panel

Optima Compact alarm fault?

Hi, my alarm is fine except, even with the alarm unset, the landing sensor causes the panel to bleep briefly every time someone walks on the landing.
I think my little boy may have pressed some buttons or maybe there is a problem with the sensor?

Steve
May 2015

Related Questions ...

Mend alarm system control panel tamper fault
17

9751 alarm with tamper fault?

Folks, I have inheritted an alarm system with the purchase of a new house. It's a Watson Alarm system but i... [Read more]
Mend fault help sensor
5

fault?

I had meesage informing me the lounge area has low battery help is it the sensor on the wall or the panel? con... [Read more]
Mend boiler heating temperature
1

diverter valve not operating?

Hi I am having a problem with my potterton performa 28i boiler. Central heating works fine. Dhw giving cold ... [Read more]
Mend changed sensor sounds
1

Fault tone on Scantronic 500+?

Hi, I changed the batteries of a PIR sensor for my scantronic 500+, now the internal fault tone sounds every 3... [Read more]
Mend set walk test
3

alarm will not set - veritas 8c?

Have tried everything in manual under trouble shooting. Alarm will not set have done all e.g the walk test, st... [Read more]
Mend engine lights going
2

engine management lights not going out?

the two stop lights on instrument panel were coming on ,the car went in for diagnosis and the fault code showe... [Read more]
Mend fault veritas 8c
4

fault with veritas 8c?

in my garage i have a texecom veritas 8c panel with a rkp at the front of the garage i hate two sensors 2 door... [Read more]
Mend tumble dryer condenser dryer fault
1

Zanussi ZDC 5370 W Cuts out after a few minutes and ideas ?

Hi, I have a Zanussi ZDC 5370 W condenser tumble dryer with a fault. The machine will start to run for a few m... [Read more]
Mend freezer ice buildup frost free
5

HOTPOINT FFA71 FREEZER HIGH TEMP LIGHT COMES ON?

ON OUR HOTPOINT FFA71 FRIDGE/FREEZER THE FREEZER HIGH TEMP LIGHT HAS BEEN COMING ON AND GOING OFF INTERMITTANT... [Read more]
Mend find disconnected main
2

How to fault find on Securitech Active 5 panel?

I disconnected a sensor without isolating the panel. The panel is now dead although the main fuse on the PCB i... [Read more]
Mend How to mend it?
1

SOLUTION wt960 f10 problem?

I had this problem with my wt960 it also showed up other fault codes.so after a bit of messing on I managed to... [Read more]
Mend alarm system sensor fault
1

Accenta 8 Alarm?

I have an Accenta 8 alarm systems linked to 8 zones. When setting the alarm it constantly beeps and never sets... [Read more]

How to mend ...

Find out how to mend just about anything howtomendit.com for free repair help, information and advice.
Mend General D.I.Y ...