Recent: Lg vcr?

Mend > Document Laminators

Mend Fellowes 65 Ultima Laminator

ultima 65 laminator?

On our ultima 65, the laminate is not sealing well on the edges

Barb
December 2013
FellowesFellowes 65Office Appliances, Document LaminatorsUltima 65 Laminator
You probably have a warpped roller or the tension is not right .Check the big set screws on the end of the rollers (top of the machine Left and right )Inside. If you have glue build up It could cause the same problem

tvrepairer
January 2014

Automatic Answer

We may have found other answers which could help you.

Click here for Ultima 65 Laminator

Related Questions ...

Mend gbc ultima hot
1

GBC Ultima 65 laminator?

My GBC Ultima 65 laminator keeps overheating because the bottom roller wasn't heating, so the top would get t... [Read more]
Mend How to mend it?
1

How do I stop the overheating of our Ultima 65 laminator?

My school has the Ultima 65 laminator, until recently it worked fine just had to change the rolls of paper. Un... [Read more]
Mend laminator ultima 65
2

Laminator gbc ultima 65 How to reinstall a power switch?

I had a wire burn out to the power switch and it burned a post off the switch. I have purchased a new switch a... [Read more]
Mend heat ready laminator
1

Heat light continues to flash on my GBC Ultima 65 even though it is ready?

The heat light continues to flash on my laminator even though it says it's ready. Why is that?
Mend plug power motor
1

how can i fix my lamintor?

how can I fix my ultima 65 laminator? ...I plug it in and the power wont go on....is the motor shot?
Mend comes while shuts
2

Laminator comes on for a while and then shuts down?

GBC Ultima 65 laminator comes on and seems to be warming up and then trips circuit breaker never reaching temp... [Read more]
Mend ultima over heating
1

Ultima 65 over heating?

Ultima 65 ready light never shows ready, it continues to blink, but the laminator is getting very hot, too hot... [Read more]
Mend 65 light not turning
1

GBC Ultima 65 ready light not turning on?

Hi, Our GBC Ultima 65 laminator stays on wait light continually. The ready light will not come on, however... [Read more]
Mend gbc ultima 65 laminator
2

GBC Ultima 65 Laminator?

Laminator runs fine for about 2-3 feet of lamination, then just stops-power is on, heat is on, rollers just st... [Read more]
Mend ultima put t
1

Ultima 65 Laminator. I put 27" film and now can't get it out?

I put the 27" film on the rod and it was hard to get into the machine. Now I can't get it out.
Mend temp knob main
2

How can I fix my Gbc Laminator?

I have A GBC Ultiam 65 laminator it is getting to hot. It has no temp control knob. Could it be the main boa... [Read more]
Mend gbc ultima 65 laminator
1

GBC Ultima 65 laminator roller not heating?

Hi, we have a GBC Ultima 65 laminator that is only getting hot enough to seal on the top roll. Bottom roller i... [Read more]
Mend 65 up will not run
1

GBC Ultima 65 will heat up but will not run?

The only problem , until now, was that it would sometimes try to go in reverse when were pushing "run" and fee... [Read more]
Mend reset started work
1

GBC Ultima 65 keeps throwing reset button?

I have a GBC Ultima 65 laminator that started throwing the reset button ever so often. Pushed the reset button... [Read more]
Mend laminator heat gbc
1

Ultima 65 laminator heat up but does not run when button is pushed?

Our GBC ultima 65 laminator turns on and heats up. When the heat indicator shows that it is ready, I push the... [Read more]
Mend Office Appliances, Document Laminators

G5640 Laminator?
Mend ultima put t

Ultima 65 Laminator. I put 27" film and now can't get it out?
Mend jammed screws top

How can I fix Fellows Home Laminator MarsA4?
Mend machine works light

How can I fix my 4250 laminator?
Mend not heating up

Not heating up?
Mend Office Appliances, Document Laminators

How to Remove an item from a Fellows Mars A4 laminator?
Mend ultima 65 laminator

ultima 65 laminator?
Mend Office Appliances, Document Laminators

How do I replace a fuse in the 4250?
Mend Office Appliances, Document Laminators

I want to lower the temp on my laminator 4250?
Mend Office Appliances, Document Laminators

New motor for fellowes laminator?
Mend unit light runs

ultima65 laminator no heat?
Mend ultima over heating

Ultima 65 over heating?

How to mend ...

Find out how to mend just about anything howtomendit.com for free repair help, information and advice.
Mend Document Laminators ...

Other models...

Fellowes 4250Fellowes MARS A4Fellowes Ultima 65

Related Categories

Mend Cash Registers
Cash Registers
Mend Document Shredders
Document Shredders
Mend Fax Machines
Fax Machines
Mend Photocopiers
Photocopiers

Topic

Fellowes Ultima 65 Laminator - Edge Sealing Issues