Mend > Document Laminators

Schematic to reconnect circuit board on GBC 4250?

The side compartment of our GBC 4250 laminator fell off and the wires became disconnected from the circuit board to the section that holds the power button, run,stop, etc... I cannot find a schematic anywhere that shows me how to reconnect the wires. They are all color coded on the circuit board side but there are no corresponding colors on the power button side. I think this can be an easy fix if I can just figure out which wire goes with which "plug". Any help would be appreciated. Thanks!

TVMS
February 2013

GBC GBC 4250 Office Appliances, Document Laminators Circuit Board Fell

Try this document.

https://www.adss.net/documents/parts/4250_PARTS.pdf

Jeanie
November 2018

why don't you get the person who broke it then to fix it ?I mean front panels don't just get knocked off they contain mains voltages,so don't come apart so easy,and I hope someone put your toys back in your pram !:-)

mm
July 2013

Try to find another 4250 and use it as a model to connect the wiring. Its far easier and faster than using a schematic...

I fix all brands of roll laminators for a living around pittsburgh and have seen customers dewire things:(

Using another identical model machne reduces the risks of mistakes which can blow the main board a 600 dollar mistake that junks the machine

bob haller service and sales pittsburgh pa 412 366 4906
February 2013

Get an internal techie with a multimeter to show you the way - not a difficult challenge.

Be collegiate....

Peccavi
February 2013

I didn't pull them off. The front compartment was knocked off by someone at my building and the wires are now disconnected. I am just trying to reconnect them the correct way so we can continue to use the laminator if it is not further broken. The school will not pay for a tech to come out. Help would be appreciated, not accusations!

TVMS
February 2013

wires dont just fall off,you pulled them off now you dont know where they go,more fool you ,at least tell us the truth mate

mm
February 2013